432418
26
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
26 CHAPTER 2: INSTALLING THE ROUTER
Nine types of serial port cables are available. However, these cables are optional
and you must select the proper one based on your requirements when you
purchase the router. All these types of cables have a DB-50 adapter at the router
end.
For pinout details of the serial port cables, see Appendix A.
At the network end, the connector is different for each type of cable, as described
in the following list:
V.24 (EIA/TIA-232) DTE cable — DB-25 (male) adapter
V.24 (EIA/TIA-232) DCE cable — DB-25 (female) adapter
V.35 DTE cable — 34-pin (male) adapter
V.35 DCE cable — 34-pin (female) adapter
X.21 DTE cable — DB15 (male) adapter
X.21 DCE cable — DB15 (female) adapter
EIA/TIA-449 DTE cable — DB37 (male) adapter
EIA/TIA-449 DCE cable — DB37 (female) adapter
EIA-530 DTE cable — DB25 (male) adapter
Use the following procedure to connect the serial cable to the SERIAL0 port and
the DSU/CSU device:
1 Turn off power to the router.
2 Choose the appropriate serial cable.
3 Plug the DB-50 adapter of the cable into the SERIAL0 port of the router.
4 Connect the other end of the cable to the CSU/DSU device. (If the WAN uses a
dial-up line, connect the cable to the serial port of the analog modem. See
“Connecting the AUX Port to the Modem” on page 25.
Connecting to the
CT1/PRI Port
The Router 3016 hass a CT1/PRI port that provides CT1 (channelized T1) access
and implements the ISDN function. See
Table 21 on page 17.
The CT1/PRI cable is a 100-ohm shielded straight-through cable with RJ-45
connectors at both ends.
For pinout details of the T1 cable, see Appendix A.
To connect the T1 cable:
1 Turn off power to the router.
CAUTION: Identify the mark on the CT1/PRI port. Plugging the connector in
incorrectly can cause damage to the router.
2 Insert the connector at one end of the T1 cable into the CT1/PRI port of the router.
3 Insert the connector at the other end of the T1 cable into the corresponding port
in a WAN device.
4 Power on the router and verify that the T1-LNK LED on the front panel of the
router chassis is lit. If it is off, check the connection cable.
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für 3com 3c13618 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info