Bedienungsanleitung 3m MP7730 (Seite 4 von 40) (Englisch)

5545

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

™

Multimedia Projector MP7730

Introduction

WARNING

Caution

Intended Use

Before operating the machine, please read the entire manual thoroughly. The 3M Multimedia Projector MP7730 was

designed, built, and tested for use indoors, using 3M lamps, 3M ceiling mount hardware, and nominal local voltages.

The use of other replacement lamps, outdoor operation, operation in environments containing heavy cigarette smoke or

different voltages has not been tested and could damage the projector or peripheral equipment and/or create a potentially

unsafe operating condition.

Important Safeguards

1. Read and understand all instructions before using. Pay particular attention to areas where these symbols are shown:

Indicates a potentially hazardous situation which,

if not avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not

avoided, could result in minor or moderate injury. It may

also be used to alert against unsafe practices.

✓

Note - Used to emphasize important conditions or details.

2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended

while in use.

3. Never look directly into the projector lens when the lamp is on. The high pressure mercury lamp produces a strong

light that could damage your eyesight.

4. Care must be taken, as burns can occur from touching hot parts.

5. Do not operate appliance with a damaged cord or if the appliance has been

dropped or damaged, until it has been examined by a qualified service technician.

6. Position the cord so that it will not be tripped over, pulled or placed in contact with hot surfaces.

7. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used.

Cords rated for less amperage than the appliance may overheat.

8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug and

pull to disconnect.

9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.

10. To reduce the risk of electric shock, do not disassemble this appliance. Take it to a qualified technician when service

or repair work is required. Incorrect reassembly can cause electric shock when the appliance is subsequently used.

11. Connect this appliance to a grounded outlet.

12. Do not expose this projector to direct sunlight or use it outside.

13. Keep all ventilation openings free of any obstructions.

14. Always open the lens shutter or remove the lens cap when the projector lamp is on.

15. Do not look directly into light beam of laser pointer. The pointer produces a strong light which could damage your

eyesight.

16. The projection lamp contains mercury. Always dispose of it in a proper manner according to local

regulations.

17. Always operate machine on a flat, sturdy surface.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

3m MP7730 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von 3m MP7730

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info