Bedienungsanleitung 3m MP7760 (Seite 4 von 36) (Englisch)

5551

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

™

Multimedia Projector MP7760

Introduction

WARNING

Caution

Intended Use

Before operating the machine, please read the entire manual thoroughly. The 3M Multimedia Projector MP7760 was

designed, built, and tested for use indoors, using 3M lamps and nominal local voltages. The use of other replacement

lamps, outdoor operation, operation in environments containing heavy cigarette smoke or different voltages has not been

tested and could damage the projector or peripheral equipment and/or create potentially unsafe operationg conditions.

Important Safeguards

1. Read and understand all instructions before using. Pay particular attention to areas where these symbols are shown:

Indicates a potentially hazardous situation which,

if not avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not

avoided, could result in minor or moderate injury. It may

also be used to alert against unsafe practices.

üü

Note - Used to emphasis important conditions or details.

2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended

while in use.

3. Never look directly into the projector lens when the lamp is on. The high pressure mercury lamp produces a strong

light that could damage your eyesight.

4. Care must be taken, as burns can occur from touching hot parts.

5. Do not operate appliance with a damaged cord or if the appliance has been

dropped or damaged - until it has been examined by a qualified service technician.

6. Position the cord so that it will not be tripped over, pulled or placed in contact with hot surfaces.

7. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used.

Cords rated for less amperage than the appliance may overheat.

8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug and

pull to disconnect.

9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.

10. To reduce the risk of electric shock, do not disassemble this appliance. Take it to a qualified technician when

service or repair work is required. Incorrect reassembly can cause electric shock when the appliance is subse-

quently used.

11. The use of an accessory attachment not recommended by the manufacturer may cause fire, electric shock, or injury.

12. Connect this appliance to a grounded outlet.

13. This unit is equipped with optical lenses and should not be exposed to direct sunlight..

14. Keep ventilation openings free of any obstructions.

15. Always operate machine on a flat, sturdy surface.

16. The projection lamp contains mercury. Always dispose of it in a proper manner according to local

regulations.

17. To avoid deposits forming on internal components, do not operate projector in extremely humid environments

(RH > 80%) or near any type of fine mist.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

3m MP7760 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von 3m MP7760

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info