Bedienungsanleitung 3m MP8750 (Seite 3 von 26) (Englisch)

654494

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

ii 3M Multimedia Projector MP8750  3M 1999

WARNING

Safeguards

INTENDED USE

Before operating the machine, please read the entire manual thoroughly. The 3M Multimedia Projector MP8750

was designed, built, and tested for use indoors, using 3M lamps, 3M ceiling mount hardware and nominal local

voltages. The use of other replacement lamps, outdoor operation, operation in environments containing heavy

cigarette smoke or different voltages has not been tested and could damage the projector or peripheral equipment

and/or create a potentially unsafe operating condition.

IMPORTANT SAFEGUARDS

1. Read and understand all instructions before using. Pay particular attention to areas where this symbol

shown.

Indicates a potentially hazardous situation which, if not avoided, could result in death

or serious injury.

Caution - Indicates a potentially hazardous situation which, if not avoided, could result in minor or

moderate injury. It may also be used to alert against unsafe practices.

ü Note - Used to emphasis important conditions or details.

2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance

unattended while in use.

3. Never look directly into the projector lens when the lamp is on. The metal halide lamp produces a strong light

that could damage your eyesight.

4. Care must be taken as burns can occur from touching hot parts.

5. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged - until it has

been examined by a qualified service technician.

6. Position the cord so that it will not be tripped over, pulled or contact hot surfaces.

7. If an extension cord is necessary, a cord with an earth/ground and a current rating at least equal to that of the

appliance should be used. Cords rated for less amperage than the appliance may overheat.

8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug

and pull to disconnect.

9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.

10. To reduce the risk of electric shock, do not disassemble this appliance or attempt to service it yourself. Take

it to a qualified technician when service or repair work is required.

Incorrect reassembly can cause electric shock when the appliance is subsequently used.

11. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric

shock, or injury to persons.

12. Connect this appliance to a grounded outlet.

13. This unit is equipped with optical lenses and should not be exposed to direct sunlight.

14. Keep ventilation openings free of any obstructions.

15. Always operate machine on a flat, sturdy surface.

16. The projection lamp contains mercury. Always dispose of it in a proper manner according to local regulations.

17. To avoid premature lamp failure, do not change the mounting position of the projector (desktop

⇒ ceiling

mount or ceiling mount

⇒ desktop mount) and continue to use the same lamp.

18. To avoid deposits from forming on internal components, do not operate projector in extremely humid

environments (RH > 80%) or near any type of fine mist.

Downloaded From projector-manual.com 3M Manuals

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

3m MP8750 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von 3m MP8750

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info