Using the magnify feature
1.
Press the ON button of MAGNIFY on the remote control.
The “MAGNIFY” indication will appear on the screen
(although the indication will disappear in several seconds with
no operation), and the projector will enter the MAGNIFY mode.
2.
Use the cursor buttons ▲/▼ to adjust the zoom level.
To move the zoom area
, press the POSITION button in the MAGNIFY mode,
then use the cursor buttons ▲/▼/◄/► to move the area. And to finalize the
zoom area, press the POSITION button again.
To exit the MAGNIFY mode and restore the screen to normal, press the O
FF
button of MAGNIFY on the remote control.
● The projector automatically exits the MAGNIFY mode when the input signal is
changed, or when the display condition is changed.
● Although in the MAGNIFY mode, the keystone distortion condition may vary, it
will be restored when the projector exits the MAGNIFY mode.
Operating
Correcting the keystone distortions
1.
Press the KEYSTONE button on the remote control. A
dialog will appear on the screen to aid you in correcting the
distortion.
2.
Use the cursor buttons ▲/▼ to correct the distortion.
To close the dialog and complete this operation, press the
KEYSTONE button again.
Even if you don’t do anything, the
dialog will automatically disappear after a few seconds.
● The adjustable range for correction will vary among inputs. For some input, this
function may not work well.
● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the
SETUP menu, if the projector screen is inclined or angled downward, this
function may not work correctly.
● When the zoom adjustment is set to the TELE (telephoto focus), this correction
may be excessive. This function should be used when the zoom adjustment is
set to the WIDE (wide-angle focus) whenever possible.
