503220
35
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
Instruction manual BFC 35
is
3. Loosen the 2 screws (A) and remove the cover (B) from the electrical
section.
The connector block (C) is now visible.
Note
Consult the table for the connections and consult the electrical diagram for
the electrical component connections.
Terminal block
3.10.3 Connecting the mains power
The water heater is supplied without a power cable and isolator.
Note
In order to receive electrical power, the water heater has to be connected to
the mains power by means of a permanent electrical connection. A double-pole
isolator with a contact gap of at least 3 mm must be fitted between this
permanent connection and the water heater. The power cable must have cores
of at least 3 x 1.0 mm
2
.
Warning
Leave the water heater electrically isolated until you are ready to
commission it.
1. Connect neutral (N), live (L) and earth ( ) of the power cable to
terminals 1 thru 3 of the terminal block as shown in the
table (3.10.2 "Preparation").
2. Fit the power cable in the strain relief.
3. Connect the power cable to the isolator.
4. If you have no more connections to make:
- Fit the cover on the terminal block.
- Fit the covers onto the water heater.
3.10.4 Isolating transformer
An isolating transformer should be used if there is a case of 'floating neutral'.
Note
The total power consumed by the appliance goes via the isolating transformer.
1. Refer to the fitting instructions provided with the isolating transformer.
(Contact the supplier for details of the correct isolating transformer.)
2. Connect the neutral (N), live (L) and earth ( ) of the power cables to
terminals 4 through 9 of the connection block according to the
table (3.10.2 "
Preparation").
3. Fit the cables in the strain relief.
4. If you have no more connections to make:
- Fit the cover on the terminal block.
- Fit the covers onto the water heater.
5. Connect the power cable to the isolator.
Mains
voltage
Isolating transformer
Alarm Out
Program-
controlled
pump
External
ON/OFF
BUS
link
primary secondary
NL NL
1
NL
2
X
1
X
2
NL
3
X
3
X
4
X
5
X
6
12345678910111213141516 to 2021222324
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für A.O. Smith BFC100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von A.O. Smith BFC100

A.O. Smith BFC100 Bedienungsanleitung und Installationsanweisung - Deutsch - 100 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 116 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info