503220
38
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
Installation
38 Instruction manual BFC
3
is
7. Connect a pressure gauge to the test nipple as soon as gas starts to flow
from it.
8. Switch on the power to the appliance using the isolator on the appliance.
9. Switch the controller ON by setting the 0/I switch to position I.
The display will now show
INTERNAL CHECK
for about 10 seconds, and
will then go to the main menu.
10. Select
SERVICE OPERATION
,
FULL LOAD
from the service menu.
11. Confirm with .
The display shown here will appear.
The appliance is now in "Full load mode" and will ignite.
12. You must wait about 1 minute after the display shows the text
RUNNING
before reading the dynamic pressures (the fan needs this time to get up to
full speed, so that you can get a reliable reading).
13. Use the pressure gauge to read the supply pressure and compare it against
the value from the gas table (3.4.3 "
Gas data").
Note
Consult the mains gas supply company if the supply pressure is not correct.
You cannot yet start using the appliance. You must now take the appliance out
of service (10.3 "
Isolating the water heater from the mains").
Note
After conversion, you must check that the gas control valve is gastight.
14. Shut off the gas supply.
15. Disconnect the pressure gauge and retighten the sealing screw in the test
nipple.
16. If there is nothing else you need to check or adjust, you can put the covers
back on the appliance.
3.11.2 Procedure for checking the gas control valve pressure
The procedure for checking the gas control valve pressure is only applicable to
appliances that have a pressure-reducing valve. If the appliance does not have
a reducing valve, continue from adjusting the CO
2
value (3.11.3 "CO
2
adjustment").
To check the gas control valve pressure, proceed as follows:
1. Isolate (10.3 "
Isolating the water heater from the mains") the appliance from
the power supply.
2. Carefully remove the covers from the appliance.
INTERNAL CHECK
SERVICE MENU
SERVICE INTERVAL
»SERVICE OPERATION
È ANTI LEGIONELLA
SERVICE OPERATION
»FULL LOAD
PARTIAL LOAD
38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für A.O. Smith BFC100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von A.O. Smith BFC100

A.O. Smith BFC100 Bedienungsanleitung und Installationsanweisung - Deutsch - 100 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 116 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info