503220
56
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
Starting the water heater
56 Instruction manual BFC
9
gis
When the water heater starts, it will run through the
following steps:
1. The water temperature drops below the set
temperature of (for example)
65
°C. The controller
detects a heat demand and starts the operating
cycle.
- The icon is activated.
- The message
HEAT DEMAND
appears.
2. Once demand is registered, the fan is started to
vent any gases that may be present. This phase is
called pre-purge and lasts about 15 seconds.
- The icon is activated.
- The message
PRE PURGE
appears.
3. During the pre-purge, the pressure switch closes.
- The icon is activated.
- The message
PRESSURE SWITCH
appears.
4. This is then followed by the (pre-)glow of the hot
surface igniter.
- The icons and are dimmed
- The icon is activated.
5. After a number of seconds pre-glow, the gas
control valve is opened and ignition takes place.
- The icon is activated.
- The message
IGNITION
appears.
6. After ignition, the flame is detected and the
appliance will be running. This means that actual
heating has started:
- The icon is dimmed.
- The icon is activated.
- The message
RUNNING
appears.
7. When the water is up to temperature, the heat
demand ceases and the post-purge starts. This
takes about 25 seconds.
- The icons , and are dimmed.
- The icon is activated.
- The message
POST PURGE
appears.
8. Following the post-purge, the fan stops and the
pressure switch opens:
- The icons and are dimmed.
- The message
POST PURGE
vanishes.
With any subsequent heat demand, the heating cycle
will resume from step 1.
ON Ê
13:45 Thursday 63ÉC
Tset 65ÉC
HEAT DEMAND
ON Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
PRE PURGE
ON Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
PRESSURE SWITCH
ON Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
GLOW PLUG
a
a
a
a
ON Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
IGNITION
ON Ê Ê Ê
13:45 Thursday 63ÉC
Tset 65ÉC
RUNNING
ON Ê Ê
13:45:00
Thursday 65ÉC
Tset 65ÉC
POST PURGE
ON
14:05 Thursday 65ÉC
a
a
a
a
56

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für A.O. Smith BFC100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von A.O. Smith BFC100

A.O. Smith BFC100 Bedienungsanleitung und Installationsanweisung - Deutsch - 100 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 116 seiten

A.O. Smith BFC100 Bedienungsanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info