503271
68
Zoom out
Zoom in
Vorherige Seite
1/126
Nächste Seite
7.8.3.5 Communication cable to solar heating system
You must connect a communication cable between the controllers of the water heater and
the solar heating system.
Connect the cables (X5 and X6) to terminals 23 and 24 as shown in the table (see
section 7.8)
.
Fit the cable in the strain relief.
If you have no more connections to make:
Fit the cover on the terminal block.
Fit the covers onto the water heater.
7.8.4 Electrical connection of the solar heating system
This section covers the following topics:
Preparation (see section 7.8.4.1);
Connecting the mains power (see section 7.8.4.2);
Connecting pump station - modulating pump (see section 7.8.4.3);
Connecting solar collector (see section 7.8.4.4);
Connecting tank sensor (see section 7.8.4.5);
Connecting top tank sensor (see section 7.8.4.6);
Connecting communication cable (see section 7.8.4.7);
Connecting Q/T sensor (see section 7.8.4.8).
7.8.4.1 Preparation
Remove the cover (snap-on type) from the terminal block for the collector. This has the
following terminals:
7.8.4.2 Connecting the mains power
Note
Just as with the water heater controller, the solar heating system controller must have a
permanent electrical connection to the mains power supply. There must be a double-pole
isolator installed in the permanent connection. This is the same double-pole isolator as
installed between the mains power supply and the water heater itself. Whenever this
isolator is operated, both controllers can be switched on or off.
Connect earth, live and neutral to terminals 1 through 3
Fit the cables in the strain relief.
Connect the power cable to the isolator.
Continue (see section 7.8.4.3).
7.8.4.3 Connecting pump station - modulating pump
The pump station contains a modulating pump (PWM controlled). You must connect this
pump to the controller of the solar heating system.
Connect earth, live and neutral to terminals 10 through 12.
Connect PWM and PWM+ to point 1 and 2 of J18.
1.
2.
3.
-
-
n
1.
2.
3.
4.
1.
2.
68 Installation, Maintenance and Service part
68

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für A.O. Smith SGS 30 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von A.O. Smith SGS 30

A.O. Smith SGS 30 Bedienungsanleitung - Deutsch - 128 seiten

A.O. Smith SGS 30 Bedienungsanleitung und Installationsanweisung - Holländisch - 120 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info