Bedienungsanleitung A.O. Smith TWI 35-130 (Seite 53 von 64) (Englisch)

503278

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Instruction manual TWI 35-130 G/TWI 45-190 G 53

In order to register your warranty, please ll in the enclosed warranty card and

return this to us. We will then send you a warranty certicate. This certicate

will entitle the owner to warranty as described below for a boiler delivered by

A.O. Smith Water Products Company B.V. in Veldhoven, that will be committed

towards the owner with respect to this.

If, within one year from the original installation date, after investigation and

exclusive evaluation by A.O. Smith, a boiler delivered by A.O. Smith turns out to

have a part, with the exception of the tank, that is not properly functioning as a

result of manufacturing or material faults, A.O. Smith will replace or repair this part.

If, within ve years from the original installation date, after investigation and

exclusive evaluation by A.O. Smith, a boiler delivered by A.O. Smith turns out

to have a stainless steel tank that is leaking as a result of rust or corrosion from

the water side, A.O. Smith will replace the entire boiler by a brand new one of

similar size and quality. The replacement boiler will have a warranty that will be

valid for the remaining period of the warranty for the original boiler delivered.

Notwithstanding the provisions in Article 2, the warranty term will be reduced

to one year after the original installation date if unltered or softened water is

owing through the boiler or left in it.

The warranty referred to in Articles 1 and 2 only apply if the following conditions

are met:

a. The boiler is installed according to the installation instructions of

A.O. Smith for the specic model as well as according to the local and

national installation and building regulations, instructions and rules.

b. The boiler will remain installed in the original installation area.

c. Only drinking water is used, which is allowed to circulate freely at all

times (a separately installed heat exchanger is obligatory for heating

saline or corrosive water).

d. The tank has been protected against harmful scale deposits by means of

periodic maintenance.

e. The boiler-water temperatures do not exceed the maximum setting of the

thermostats that are part of the boiler.

f. The water pressure and/or heat load do not exceed the maximum values

indicated on the boiler’s identication plate.

g. The boiler has not been installed in a corrosive atmosphere or

environment.

h. The boiler has been provided with a by an authorised body approved

protected cold supply setup of sufcient capacity not greater than the

operating pressure indicated on the boiler and, if applicable, with a

temperature and pressure relief valve, also approved by an authorised

body, which has been mounted according to the installation instructions of

A.O. Smith applicable to the specic boiler model as well as according to

the local and national instructions, regulations and rules.

11.1 Warranty general

11.2 Warranty tank

11.3 Conditions

of installation

and use

11 Warranty (certicate)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

A.O. Smith TWI 35-130 Seite 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von A.O. Smith TWI 35-130

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info