671770
40
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
Installation and Service Manual Upsilon-Series
40
Thestandardread-outoffers3informationscreens.
Switching to different screen scan be found using the + or - button
1. "Good"- read-out Good with actual day and time (see above)
2. Operational status Refer to chapter 9.1 for explanation of texts
3. Technical read-out Actual water ow temperature. (T1 in °C)
and water pressure (P in bar).
ForUpsilonboilersincascade
For Upsilon boilers in cascade, the bus communication cables between the boilers must
be connected (see section electrical connections).
The master-boiler (address 01) should be set to how many boilers are actually connected.
From the standard display with illuminated display (blue):
1. Press 2 seconds the arrow keys simultaneously (green display);
2. Use the right arrow button until: Param Mode;
3. Press the OK button; Cascade param. is shown;
4. Press the OK button again;
5. Push the right arrow key until P114;
6. Press the OK button;
7. Press the + key until the total number of boilers in cascade:
8. Press the OK button;
9. Press the return key until standard read-out
SwitchingontheHeating,DHWandPumpprogram
By switching on the functions (
, and/or ) the boiler is turned on.
Proceed as follows:
From the standard display with illuminated display:
1. Press the right arrow button:
The display shows: Basic settings;
2. Press the OK button;
3. Press the right arrow button:
The display shows: CH prog off;
4. Press the + button:
The display shows: CH prog on;
5. Press the OK button;
6. Repeat the procedure from point 3.
In this way the functions DHW and Pump can be switched on.
7. Press the return button to go back to the standard display.
Depending from the programs that are switched on the corresponding symbols will be
shown.
Standby
Good
we 10:17
20.0 °C
1.65 bar
1
2
3
OK
-
+
OK
-
+
Param
Mode
Cascade
paramtr
P114
1
Basic
Settings
CH prog
off
CH prog
on
CH DHW Pump
40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für A.O. Smith Upsilon UB-70 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von A.O. Smith Upsilon UB-70

A.O. Smith Upsilon UB-70 Bedienungsanleitung - Englisch - 2 seiten

A.O. Smith Upsilon UB-70 Zusatzinformation - Englisch, Holländisch - 2 seiten

A.O. Smith Upsilon UB-70 Bedienungsanleitung - Holländisch - 2 seiten

A.O. Smith Upsilon UB-70 Installationsanweisung - Holländisch - 72 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info