Bedienungsanleitung AAS String Studio VS-1 (Seite 47 von 71) (Englisch)

541313

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

4.17 The Arpeggiator Module 47

when it is turned clockwise the depth of the vibrato will increase when the modulation wheel is

used. The increase is always relative to the position of the Amount knob and will be greater as the

Mod knob is turned clockwise.

The vibrato can be adjusted not to start at the beginning of a note but with a little lag. This

lag is set by the Delay knob. The Fade knob allows you to set the amount of time taken by the

amplitude of the vibrato effect to grow from zero to the amount set by the Amount knob.

The last parameter is used to add liveness to the sound. When several musicians play together,

they do not necessarily start their vibrato exactly at the same time, speed and amplitude. The

Error knob is used to produce this effect by adding an error to the Rate, Amount, Delay and Fade

parameters of the vibrato of each polyphonic voice. As the Error knob is turned clockwise, the

larger will be the difference between the vibrato effect applied to each voice. In its leftmost position

there is no added error and all the voices are played with exactly the same vibrato effect.

4.17 The Arpeggiator Module

The Arpeggiator module allows one to play sequentially all the

notes that are played on the keyboard. In other words, arpeggios

are played rather than chords. The modules allows one to produce

a wide range of arpeggios and rhythmic patterns and to sync the

effects to the tempo of an external sequencer.

4.17.1 Arpeggio Patterns

The arpeggio pattern is set by the combination of the value of the

Range, Span and Order controls. The Range control is used to select

the number of octaves across which the pattern will be repeated. When the range is set to 0, there is

no transposition and only the notes currently depressed on the keyboard are played. If set to a value

between 1 and 4 (its maximum value), the notes played are transposed and played sequentially, over

a range of one or more octaves depending on the value of the Range parameter. The direction of

the transposition is set with the Span drop-down menu. This parameter can be adjusted to Low for

downwards transposition, to High for upwards transposition or Wide for transposing both upwards

and downwards. Finally, the Order control sets the order in which the notes are played, therefore

determining the arpeggio pattern. When set to Forward, the notes are played from the lowest to the

highest. When set to Backward the notes will be played from the highest to the lowest. In the two

last modes, Rock and Roll exclusive and Rock and Roll inclusive, the note will be played forward

from the lowest to the highest and then backward from the highest down to the lowest. When using

the RnR exclusive mode, the highest and the lowest notes will not be repeated when switching

direction but in RnR inclusive mode these notes will be repeated. Finally, in Chord mode, all the

notes are played at once.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AAS String Studio VS-1 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info