Bedienungsanleitung AAS Strum Acoustic Session (Seite 24 von 77) (Englisch)

541318

Zoom out

Zoom in

Vorherige Seite

1/77

Nächste Seite

24 Keyboard Layout

the remaining arp keys. Finally, if the alternate bass is the ﬁfth and if it can only played on

the string on which it is played in the chord, it is triggered by the alternate bass arp key and

it is not repeated on another arp key.

These rules imply that the arp keys 6 to 1 do not necessarily correspond to string 6 to 1 (lowest

to highest). In fact they only do when the six strings are used in a chord and when the bass is played

on string 6. This is true for example with bar chords played using the six strings. To illustrate these

rules lets consider different chords played in movable position. A G major chord with bass played

on G2 on the keyboard will be voiced by Strum Session with the bass on the sixth string. The

arp key will then follow the order of the guitar strings. Playing a C major chord with the bass

played on C3 on the keyboard results in a chord voiced by Strum Session with the bass on string

5 and the alternate bass on the sixth string. The bass and alternate bass arp keys will therefore

trigger the ﬁfth and sixth string respectively. The remaining arp 4,3,2,1 keys will trigger the fourth,

third, second and ﬁrst strings respectively. Finally, playing a G Major chord one octave higher than

previously (bass on G3 on the keyboard) results in a chord played by Strum Session on the four

highest strings of the guitar (strings 4,3,2,1). In this case, the bass arp key will trigger the fourth

string, the alternate bass will be played on the ﬁfth string and the remaining three notes of the chord

(strings 3, 2 and 1) will be triggered by arp keys 4, 3 and 2 respectively. The ﬁrst string will also

be triggered by arp key 1.

3.3 Pitch Bend Wheel

The pitch bend wheel produces a slide or a bend depending of the settings of the Pitch Wheel

section of the interface. The Range parameter is used to determine the number of semi-tones in the

slide or bend.

In slide mode, all the strings played in a chord are slided. It is not possible to play lower than

the lowest note of a string when sliding downward. In this case, the slide range will be limited.

In bend mode, only one string is bended at a time. If a chord was just strummed, the highest

note of the chord is bended. If an individual note was just played, this note is bended.

3.4 Aftertouch

In Strum Session, bending can be controlled using monophonic aftertouch (also known as channel

pressure on certain controllers). The pitch of the note can be increased in this way by up to one

tone depending on the settings of the Bend control of the Aftertouch section of the interface. If a

chord was just strummed, the highest note of the chord is bended. If an individual note was just

played, this note is bended.

3.5 Modulation Wheel

The modulation wheel is used to control vibrato.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AAS Strum Acoustic Session Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info