Bedienungsanleitung AAS Strum Electric GS-1 (Seite 53 von 98) (Englisch)

541315

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

6.4 The Multi-Effect Module 53

6.4 The Multi-Effect Module

The Multi-Effect module allows one to process the out-

put signal from the guitar and the ampliﬁer. There are in fact

two sets of effects, a ﬁrst one called Pre which can be ap-

plied before the ampliﬁer and a second one, Post, which can

be used for processing the output from the ampliﬁer. The Pre

and Post effects are activated by switching on or off by click-

ing on the corresponding On button.

The effect applied in Pre or Post conﬁguration is selected

from the Type drop-down menu. Available effects include three different types of delays (ping

pong, digital and tape), chorus, ﬂanger, phaser, auto wah, wah wah, notch ﬁlter and tremolo.

The different effects can be synchronized to the clock of a host sequencer using the Sync drop-

down menu. Sync values range from 1/8 of a quarter note (a thirty-second note) to 16 quarter notes

(4 whole notes) where the duration of the whole note is determined by that of the sequencer clock.

The effect can also be synced to a triplet (t) or dotted note (d).

Each of the effect of the module can be controlled using three offset knobs. When in their center

position, the effect is adjusted according to the factory settings. Turning the knobs to clockwise or

anti-clockwise allows one to deviate from this default setting as described below.

6.4.1 Delay

The Multi-Effect module includes 3 different types of delay effects: Ping Pong, Digital and Tape

Delay. The Digital delay consists in a standard delay line with feedback. The tape delay is similar

but also includes a low-pass ﬁltering effect in order to simulate the attenuation of high frequencies

in analog tape delays. The Ping Pong delay is based on two delay lines resulting in a signal traveling

from one channel to the other, each time attenuated by a coefﬁcient.

The Wet knob is used to adjust the amount of “wet” signal present in the output signal from the

effect. When the knob is adjusted in the left position, only the original or “dry” signal is sent to the

output. Turning this knob clockwise increases the amount of processed or “wet” signal sent to the

output. In its rightmost position, only “wet” signal is present in the output signal. The Feedback

knob is used to adjust the amount of signal re-injected into the delay lines or in other word the

amount of feedback introduced in the line. In its leftmost position, there is no signal re-introduced

and the effect module only delays the input signal. Turning this knob clockwise increases the

amount of signal reﬂected back at the end of the line. Finally the Time knob controls the length of

the delay lines and therefore the delay between echoes.

6.4.2 Chorus

The Multi-Effect module includes both a mono and stereo chorus effect. The chorus effects can

be controlled with the three knobs appearing at the bottom of the module. The Mix knob is used to

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AAS Strum Electric GS-1 Seite 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info