22
GB: English Manual Gewa Control 10
Introduction
The Gewa Control 10 is a programmable IR transmitter, which replaces ordinary remote
controls for TV, DVD, stereo etc. It has in all 36 different programming positions on four
levels. Simply press the buttons to send signals, and change level by pressing the Level-
button.
The Control 10 is a part of the “Gewa Smart House” concept and therefore can be used
together with all of these products.
News and improvements
Control 10 is improved in several ways compared to the earlier generation IR-9SP:
New design on casing
Improved battery warning
Improved labelling of the buttons
Place for level indication has been moved
General information about Control 10
To be able to use your Control 10 there are certain things that you should know:
The Control 10 is delivered preset with GewaLink channels, meaning that it is possible
to use the transmitter immediately after the batteries has been inserted. See section
Inserting Batteries.
To enter the programming mode, press the Programming button using a paper clip, for
example, at the same time as you choose a Function-button. Different Function-
buttons are chosen depending on what is to be programmed.
If you press the wrong button or make a mistake when programming you can always
press the Programming button for two seconds. It works as a Reset-button.
It is important not to wait too long between the different steps when programming. After
a certain time Control 10 automatically leaves the programming state to save power.
If a button on your Control 10 is pressed for more than 25 seconds, your Control 10 will
stop transmitting to save power.
The settings can be protected by using the Settings Lock.
You can only change the settings of levels that are unlocked.
