25
1.2 General information about Control Medi
To be able to use your Control Medi there are certain things that you should know:
• The Control Medi is delivered preset with GewaLink channels, meaning that it is
possible to use the transmitter immediately after the batteries has been inserted. See
section Inserting Batteries.
• To enter the programming mode, press first the Level button and then simultaneously
one of the Function buttons for 2 seconds (2 seconds applies from version 1.0.6 or
serial no: 800402). Different Function buttons are chosen depending on what is to be
programmed.
• If you press the wrong button or make a mistake when programming you can always
press the Level button for two seconds. It works as a Reset button.
• It is important not to wait too long between the different steps when programming. After
a certain time your Control Medi automatically leaves the programming mode to save
power.
• If a button on your Control Medi or control switch is pressed for more than 1 minute,
your Control Medi will stop transmitting to save power.
• The settings can be protected by using the Settings Lock.
• You can only change the settings of levels that are unlocked.
This picture shows the various terms and functions which are described in the text.
1.3 Symbols
The following symbols appear in the text throughout this manual:
