677159
10
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
10
transmitters only emit a short flash each time the key is pressed. In these
cases, press several times.
5. Press and release the key on Control Prog that is to be programmed. The
indicator light for the level key now emits a steady orange light.
6. Press and hold the corresponding key on the original transmitter pressed.
Release the key when the indicator light for the level key gives a green light.
This might take up to 10 seconds. If the indicator light goes orange again
press the key one or more times until it flashes green and goes out. If the
indicator light flashes red the programming has failed. Try once more from
step 4. If a beep
is heard the level is locked and no programming can be
made. Read the next section how to unlock a level.
7. If the programming of the first key was successful, repeat steps 5 and 6 until
all keys are programmed. Finish by pressing
---
. The indicator light for the
level key flashes green to show that the programming is complete.
8. Now test the programmed functions on the device that is to be controlled.
Quick guide
Programming:
P
+
1
,
X
,
Y
, ….
---
Tip! Control Prog can record codes from most IR transmitters on the market
with a few exceptions. You may have problems with a few or all of the functions
for a certain IR transmitter. In these cases it is possible to try another recording
method. Instead, do as follows in step 4; Press
P
and
1
at the same time but
keep them pressed for approximately 2 seconds until the indicator light for the
level key flashes green and goes out. Control Prog is now in another recording
mode. Otherwise use the same recording procedure.
Locking/Unlocking Delete Protection
In order to protect codes from being deleted by accident when new codes are
programmed it is possible to lock each level separately. Locked level is
indicated by a beep
and no programming can be made. Do as follows to
lock/unlock levels:
1. Press
P
and
---
at the same time. The indicator light for the level key and the
current level are now lit.
2. Change to the level to be locked/unlocked by pressing
---
as many times as
needed.
3. Press
3
to lock or
4
to unlock. The indicator light for the levels is
automatically moved to the next level, which thereby can be locked/unlocked
immediately.
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Abilia Manual Control wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Abilia Manual Control

Abilia Manual Control Bedienungsanleitung - Deutsch - 48 seiten

Abilia Manual Control Bedienungsanleitung - Holländisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info