In battery operation mode, the sounder is automatically muted after 3 minutes.
In addition, battery-saving functions are enabled.
The software version of the sounder is indicated by the LEDs immediately after the
power supply is connected. You can find details on this in the chapter "Software
version displayed by LEDs".
Step 4b: Pair the sounder with the alarm panel
• If this has not been done already, start operation of the alarm panel.
• Select:
Installer mode -> Components -> Indoor sounder > Add/remove > Indoor sounder 0x
• Select the desired position. Indoor sounder 01 to indoor sounder 04
• You will receive the message "Activate the tamper contact of the indoor sounder". Flick
the tampering switch.
Image 5
• The sounder will then send a pairing signal to the alarm panel. The alarm panel will
recognise the sounder. Once the pairing signal has been received by the wireless alarm
system, it will emit two beeps. The notification "Indoor sounder added" and the incoming
signal strength will be displayed.
• Confirm the successfully completed pairing on the alarm panel.
• On the alarm panel, you can go to
Installer Mode -> Components -> Indoor sounder -> Edit ->
to determine which partitions the indoor sounder should report on. You can also assign
an individual name here.
• You can find descriptions for all further programming in the corresponding chapters of
the Secvest installer manual.
