Bedienungsanleitung Abus TVAC18000A (Seite 36 von 151) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

692264

Zoom out

Zoom in

Vorherige Seite

1/151

Nächste Seite

English

7. Wireless transmission

The wireless range depends on a variety of environmental factors. The local conditions at the installation

site may have a negative impact on the range. When there are no obstructions between the receiver and

transmitter, a range of up to 150 m is possible, but this range will be considerably less within buildings.

The following environmental conditions compromise both the range as well as the frame rate:

Mobile communication masts, high-tension pylons, electrical wires, ceilings and walls, devices with the

same or an adjacent wireless frequency.

Warnings

Observe all safety and operating instructions before putting the device into operation for the first time.

1. Observe the following information to avoid damage to the mains cable and plug:

• Do not modify or manipulate the power cable or plug.

• Do not pull the cable when disconnecting the device from the mains power – always hold of the plug.

• Ensure that the mains cable is positioned as far away as possible from any heating equipment, as this

could otherwise melt the plastic coating.

• The power supply unit for the door station must be protected from damp and moisture.

2. Follow these instructions. Non-compliance with these instructions could lead to an electric shock.

1. Never open the housing or power supply unit.

2. Do not insert any metallic or flammable objects into the device.

3. Use overvoltage protection to prevent damage caused by overvoltage (e.g. electrical storms).

3. Disconnect defective devices from the power immediately and contact your specialist dealer.

When installing the device in an existing video surveillance system, ensure that all devices have

been disconnected from the power supply and low-voltage circuit.

If in doubt, have a specialist technician carry out assembly, installation, and connection of the

device. Improper or unprofessional work on the power supply or domestic installation puts both

you and other persons at risk.

Connect the installations so that the power supply circuit and low-voltage circuit always run

separately from each other. They should not be connected at any point or be able to become

connected as a result of a malfunction.

Avoid the following adverse conditions during operation:

• Moisture or excess humidity

• Extreme heat or cold

• Direct sunlight

• Dust or flammable gases, vapors, or solvents

• Strong vibrations

• Strong magnetic fields (e.g. next to machines or loudspeakers)

• The camera for the door station must not be directed toward the sun, as otherwise the sensor may be

destroyed.

• The camera must not be installed on unstable surfaces

Unpacking the device

Handle the device with extreme care when unpacking it.

If the original packaging has been damaged, inspect the device. If the device shows signs of

damage, return it in the original packaging and inform the delivery service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Abus TVAC18000A Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info