Bedienungsanleitung Abus tvip72500 (Seite 42 von 60) (Englisch)

756514

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

WLAN antenna (TVIP71551 only)

The camera features a WLAN network interface for wireless data transmission in an IP network. The network

camera must be connected via a network cable for the initial configuration of all WLAN parameters.

WLAN: Enable or disable the WLAN interface.

MAC address: Shows the MAC address of the wireless interface.

IP address: The set IP address is displayed here. The address can be assigned

automatically (DHCP) or manually (see below).

WLAN status display: The camera automatically searches the environment for WLAN access points

(APs).

ESSID: Shows the name of the wireless network. If a connection to an access point

has been established, this is indicated by the character “v” before the ESSID

name.

Signal strength: Shows the signal quality in percent. To ensure a good connection, this value

should not be below 60%.

Security: Indicates the way in which the network is protected (encryption type).

Wireless mode: Shows the WLAN standard that the access point (AP) supports.

Connect: When this button is pressed, the software attempts to connect to the selected

access point. Additional data important for the connection must be configured

in another window (it may be necessary to disable the pop-up blocker). The

IP address is automatically determined.

Disconnect: The connection to the selected access point is disconnected.

Manual: Manual configuration of all data required for a wireless connection.

Update: When this button is pressed, the list of available access points is updated.

ESSID: The ESSID is the name of the access point.

Manual setting: Manual setting of the ESSID.

Mode: Select the WLAN connection mode here.

Infrastructure The network camera is connected to the network via an access point.

Ad-Hoc In this mode, the network camera can communicate directly with another

network adapter (network card). What is known as a peer-to-peer

environment is set up.

Authentication: Here you can set the encryption mode for the wireless transmission.

Open No encryption selected.

Common key (WEP, Wired Equivalent Privacy) A 64- or 128-bit key is used for encryption

(HEX or ASCII). For communication with other equipment, these keys must

be the same on both devices.

(10/26 HEX characters or 5/13 ASCII characters according to bit length)

WPA-PSK/WPA2-PSK (Wi-Fi Protected Access – Pre-Shared Keys) With this method, dynamic keys

are used. TKIP (Temporal Key Integrity Protocol) or AES (Advanced

Encryption Standard) can be selected as the encryption protocols. What is

known as a passphrase (pre-shared key) must be assigned as the key.

(64 HEX characters or 8 to 63 ASCII characters)

Encryption: Select the corresponding type of encryption here.

Common key: WEP / disabled

WPA-PSK / WPA2-PSK: TKIP or AES

Key length: With WEP only. Select the bit length for the key here.

Network key: With WEP only. Up to four keys can be assigned.

Obtain IP address automatically: The IP address, subnet mask, and address for the default gateway are

obtained automatically from a DHCP server. An activated DHCP server

must be present in the network in this case.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Abus tvip72500 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Abus tvip72500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info