How to use your Stereo Bluetooth Speakers
1. Plug in the mains adaptor.
2. Separate the speakers from the amplifier unit if required - the
cable simply unwinds from the back of the speakers. The speakers
can be disconnected from the amplifier unit by holding it and sliding
the speakers forward.
3. Turn on via the large silver knob on front – The LED light should
flash green slowly, showing that the unit is in standby mode.
4. To connect an A2DP stereo Bluetooth device for the first time:
a. Hold down the MFB for approximately 8 seconds
until the LED flashes red/green.
b. Search for the Stereo Bluetooth Speaker system
on your Bluetooth device and pair with it once you’ve
found it. See your device’s (e.g. mobile phone) user
manual for more detail on this.
c. Enter the pass-code, which is 8888.
d. Once you have successfully paired the speakers
and your device, the LED will blink 5 times.
e. This can be repeated if you would like to pair with
an alternative device at any time.
5. To connect to the Stereo Bluetooth device that was last used,
press the MFB once when in standby mode.
6. To play a hard wired source such as a digital music (MP3 etc)
player, simply connect the source in to the mini jack connector on
the rear of the unit and adjust the volume knob until it’s at the level
you want.
Please note that this will disconnect the Bluetooth device and the mini-jack
will have to be removed to return to a Bluetooth connection!
on / off
volume
status LED
multi function button
(MFB)
3.5mm jack
speaker connectors
12v DC jack
Item
Power On
Product Name
General Specification
Stereo Bluetooth Speaker
Model Number AE29-06C
Type Stereo Active Bluetooth Speaker System
2 x 10 W
Power Output
Frequency response +/- 3dB 70Hz - 18KHz
Drive Unit Full range, low distortion, woven glass
Dimensions 387 x 155 x 130
2.25Kg
Weight
Bluetooth Standard V1.2
Internal
10m
Bluetooth A2DP Profile For compatibility with any Bluetooth audio devices
to perform stereo audio streaming
Theoretical range in open field
Antenna
8 OhmsSpeaker Impedance
Standby
Paired
Successfully
No Pairing found
Standby
(abnormal
disconnection)
Re-link with the
last connected
device
Hardwired Mode
Blink Green
Steady Orange
Blink Green
(5 times rapidly)
Blink Orange
(5 times rapidly)
Blink Green
Pairing
Exit Pairing
In standby mode, press and
hold the MFB for 8 seconds
Blink Green & Red
Steady Green
(for 3 sec)
Connect power & turn knob
front
back
Action LED Status Note
System will re-link with the
last connected A2DP device
automatically within 10
minutes
If nothing pairs within 2
minutes, the system will exit
pairing mode, and enter
standby mode.
In pairing mode, press and
hold MFB for 8 Seconds
Press MFB once in
standby mode
Plug source into min-jack
connector on rear of unit
This will disconnect feed from
bluetooth module
Products that display the crossed-out wheeled bin logo cannot be disposed of as
domestic waste but must be taken to a facility capable of recycling them and
appropriately handling any waste by-products. Contact your local authority for details of
the nearest such facility.
