Bedienungsanleitung ACP JET514 (Seite 3 von 15) (Englisch)

660213

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Installation

Unpacking Oven

• Inspect oven for damage such as dents in door or inside oven cavity.

• Report any dents or breakage to source of purchase immediately.

Do not attempt to use oven if damaged.

• Remove all materials from oven interior.

• If oven has been stored in extremely cold area, wait a few hours before

connecting power.

Radio Interference

Microwave operation may cause interference to radio, television, or a similar

oven. Reduce or eliminate interference by doing the following:

• Clean door and sealing surfaces of oven according to instructions in

Care and Cleaning section.

• Place radio, television, etc. as far as possible from oven.

• Use a properly installed antenna on radio, television, etc. to obtain

stronger signal reception.

Oven Plment

• Do not install oven next to or above source of heat, such as pizza oven

or deep fat fryer. This could cause microwave oven to operate

improperly and could shorten life of electrical parts.

• Do not block or obstruct oven lter. Allow access for cleaning.

• Install oven on level countertop surface.

• If provided, place warning label in a conspicuous place close to

microwave oven.

• Outlet should be located so that plug is accessible when oven is in place.

Oven Clearances

A—For North American (UL/CSA) models, allow at least 2” (5.1 cm) of

clearance around top of oven. Proper air ow around oven cools

electrical components. With restricted air ow, oven may not operate

properly and life of electrical parts is reduced.

B—There is not an installation clearance requirement for the back of the

oven.

C—Allow at least 1” (2.54 cm) of clearance around sides of oven.

D—Install combination oven so oven bottom is at least 3 feet (91.5 cm)

above oor.

To avoid risk of electrical shock

or death, this oven must be

grounded and plug must not be

altered.

Earthing

Instructions

Oven MUST

be grounded.

Grounding reduces

risk of electric shock by providing an

escape wire for the electric current

if an electrical short occurs. This

oven is equipped with a cord having

a grounding wire with a grounding

plug. The plug must be plugged into

an outlet that is properly installed

and grounded.

Consult a qualied electrician or

servicer if grounding instructions

are not completely understood, or if

doubt exists as to whether the oven

is properly grounded.

Do not use an extension cord.

If the product power cord is too

short, have a qualied electrician

install a three-slot receptacle.

This oven should be plugged

into a separate circuit with the

electrical rating as provided in

product specications. When the

combination oven is on a circuit with

other equipment, an increase in

cooking times may be required and

fuses can be blown.

External Equipotential

Earthing Terminal (export only)

Equipment has secondary earthing

terminal. Terminal provides external

earthing connection used in addition

to earthing prong on plug. Located

on outside of oven back, terminal is

marked with symbol shown below.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ACP JET514 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ACP JET514

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info