660217
6
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
6
Display and Features (cont’d)
Start pad
The Start pad is used
to begin a manual time
entry cooking cycle.
Temperature warnings
The combination oven has two
distinct temperature warnings.
Warnings sound with a three beep
signal when a programmed pad is
pressed. Warnings are:
A warning when the preheat
temperature does not match the
preprogrammed temperature of
a cooking condition.
A warning when the actual
oven cavity temperature is
not to preheat temperature,
such as when the oven is rst
started.
To override the warning and begin
a cooking cycle, press the Start
pad. To turn off warnings, see
User Options section.
Stop/Reset pad
The Stop/Reset pad
stops a cooking
sequence in progress,
clears out any remaining time,
and also ends a programming
or user option cycle. When the
Stop/Reset pad is used to end a
programming or option change,
the changes are discarded.
Cooking Display
DISPLAYS DESCRIPTION
OVEN PREHEATING
475°F
Oven Preheating 475°F or 250°C displays
when oven is turned on and is warming up to the
selected preheat temperature. Oven Preheating
also ashes when a cooking condition can be
started or programmed.
READY
475°F
Ready 475°F or 250°C displays when oven has
reached preheat temperature and is ready to cook.
Ready also ashes when a cooking condition can
be started or programmed.
Note: Oven will shutdown after two hours of
inactivity.
00:00
Displays cooking time. If stage cooking is
programmed, total cooking time is displayed
.
MW 50%
MW 50% displays the current microwave power
level. 100% is the highest setting, and 0% is lowest
(no microwave energy used).
ITEM-05
ITEM-05 displays the single or double digit entry
of a programmed cooking condition when using a
programmed pad.
STAGE 1
Stage 1 displays the stage number (1 through 4)
the oven is at in the cooking condition
.
STANDBY
STANDBY displays when oven is turned off,
and also after the oven is plugged in, the door is
opened, and then shut.
Programming Display
DISPLAYS DESCRIPTION
Enter Program
to Add/Review:
Displays when oven is in programming mode for
single digit or double digit memory.
STAGE 1
Displays stage number during cooking or when
programming a specic cooking stage. Stage
number (1 through 4) indicates the stage that is
being used.
USB Display
DISPLAYS DESCRIPTION
USB
Displays when keypad 5 is pressed and held and
transfer to or from USB ash drive is ready
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für ACP JET519v3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von ACP JET519v3

ACP JET519v3 Bedienungsanleitung - Deutsch - 15 seiten

ACP JET519v3 Bedienungsanleitung - Holländisch - 15 seiten

ACP JET519v3 Bedienungsanleitung - Französisch - 15 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info