Bedienungsanleitung ACP MOC24 (Seite 5 von 12) (Englisch)

660235

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Unpacking Oven

• Inspect oven for damage such as dents in door or inside oven cavity.

• Report any dents or breakage to source of purchase immediately.

Do not attempt to use oven if damaged.

• Remove all materials from oven interior.

• If oven has been stored in extremely cold area, wait a few hours before

connecting power.

Radio Interference

Microwave operation may cause interference to radio, television, or a similar

oven. Reduce or eliminate interference by doing the following:

• Clean door and sealing surfaces of oven according to instructions in

Care and Cleaning section.

• Place radio, television, etc. as far as possible from oven.

• Use a properly installed antenna on radio, television, etc. to obtain

stronger signal reception.

Oven Placement

• Do not install oven next to or above source of heat, such as pizza

oven or deep fat fryer. This could cause microwave oven to operate

improperly and could shorten life of electrical parts.

• Do not block or obstruct oven louvers.

• Oven may be stacked.

• Install oven on level countertop surface or overshelf.

• If provided, place warning label in a conspicuous place close to

microwave oven.

• Outlet should be located so that plug is accessible when oven is in place.

For Enclosed Installation

For North American (UL/CSA) models, there are no installation

clearance requirements

Installation

To avoid risk of electrical shock or

death, this oven must be grounded.

The switching operation of this microwave oven can cause voltage uctuations on the

supply line. The operation of this oven under unfavorable voltage supply conditions

can have adverse effects. This device is intended for the connection to a power

supply system with a maximum permissible system impedance Zmax of 0.31 Ohm

at the interface point of the user’s supply. The user has to ensure that this device

is connected only to a power supply system which fullls the requirement above.

If necessary, the user can ask the public power supply company for the system

impedance at the interface point.

To avoid risk of electrical shock

or death, do not alter the plug.

Oven MUST be grounded.

Grounding reduces risk of electric

shock by providing an escape wire

for the electric current, if an electrical

short occurs. This oven is equipped

with a cord having a ground wire

with a grounding plug. The plug

must be plugged into an outlet that is

properly installed and grounded.

Consult a qualied electrician or

servicer if grounding instructions

are not completely understood, or if

doubt exists as to whether the oven

is properly grounded.

Do not use an extension cord.

If the product power cord is too

short, have a qualied electrician

install a three-slot receptacle.

This oven should be plugged

into a separate circuit with the

electrical rating as provided in

product specications (available

on acpsolutions.com). When a

microwave oven is on a circuit with

other equipment, an increase in

cooking times may be required and

fuses can be blown.

External Equipotential

Earthing Terminal (export only)

Equipment has secondary earthing

terminal. Terminal provides external

earthing connection used in addition

to earthing prong on plug. Located

on outside of oven back, terminal is

marked with symbol shown below.

WARNING

Grounding Instructions

Improper use of the grounding can

result in a risk of electric shock.

WARNING

(Export/50 Hz Only)

For all international models (50 Hz)

A - Allow at least 7” (18 cm) of clearance around the top of the oven.

Proper air ow around the oven cools electrical components. With

restricted air ow, the oven may not operate properly and life of electrical

parts is reduced.

B - Allow at least 1” (2.54 cm) on sides of oven.

C - There are no clearance requirements for the back of the oven.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ACP MOC24 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ACP MOC24

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info