Bedienungsanleitung ACV GLASS BL - ST (Seite 15 von 28) (Englisch, Holländisch, Französisch)

677363

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

DEAR USER!

We ask you to read this installation and operation manual by paying much attention before using

the appliance.

The electric connection, the connection to the water network and the first starting up must be

realised by your installation technician. The appliance is not a toy. It must not be used by persons

with physical, mental or sensorial handicap (including children) and by persons without enough

experience.

Such persons may use the appliance in presence of a person taking care of their security or by

following their instructions.

Do not leave children without attendance and you should make sure that they do not play with the

appliance.

Before fixing the boiler to the wall, verify that the wall can bear the weight of the

appliance filled up with water.

CONNECTION TO THE WATER NETWORK

In the case of hydraulic connection to a

water system made of brass, it is

compulsory to use reduced dielectric sleeves

or equal male-female sleeves made of

malleable cast iron. Should the thread of the

tubes, which are not provided with such

sleeves, be attacked by corrosion, our

guaranty cannot be applicable.

The hot water-cold water connection of the

appliance should be realised by following the

diagram in fig. 1 (drawing of the boiler +

safety group) and in compliance with the

applicable legal regulations. Do not expose

the boiler to pressure exceeding 7 bars in

any case otherwise the appliance will suffer

irreparable damages. Recommended safety group: safety group of 6 bars manufactured by

RITMONIO Company, matching the tube connection of the appliance.

1. It is compulsory to mount a safety group complying with the standards to the cold water inlet of

the appliance. This combined group contains a check valve and a safety valve. This safety

valveopens where the pressure increases to 6.3 - 7 and closes at 6 bars, in addition, it has a

stopcock.

2. The discharge pipe at the outlet of the appliance should be put to a place protected from freeze,

for insuring free flow.

Strictly follow the installation diagram because the good functioning of the boiler depends on it.

3. If the operating pressure exceeds 6 bars, a pressure reducer must be mounted in front of the

safety group.

4. If one or several mixing faucets are used, a check valve is to be mounted to the cold water

column supplying the mixing faucets.A stopcock has to be placed on the cold water supply of the

appliance.

The safety group may leak, therefore the drain pipe must not be obstructed!

FUNCTIONING

This closed-system appliance is intended to

produce hot water in households and institutions.

The hot water can be used for both sanitary and

consumption purposes .

The water temperature of the boiler can be

adjusted depending on your needs (65 °C).

After having achieved the adjusted or preferred

temperature, the temperature regulator switches

off the heating automatically. In this way there is

hot water in the boiler for a long time. The

polyurethane insulation in the internal tank

prevents the fast cooling of the hot water,

therefore, the water remains hot for a long time.

Hot water flows out without mixing with cold

water.

ENG

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ACV GLASS BL - ST Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info