620411
24
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
System Control - ACVMax: 660Y2800 • B
en
24
EN
FR
NL
ES
IT
DE
PL
RU
APPLIANCE DESCRIPTION AND OPERATION
CH & DHW Settings / Boiler Settings (contd)
Flexible Pump Cong
Flex. Relay 1 (CH)
Flex. Relay 2 (DHW)
Flex. Relay 3 (P3)
Flex. Relay 4 (ERR)
Flex. Relay 5 (Flame)
Flex. Relay 6 (P4)
Flexible Pump Cong
Flex. Relay 2 (DHW)
Flex. Relay 3 (P3)
Flex. Relay 4 (ERR)
Flex. Relay 5 (Flame)
Flex. Relay 6 (P4)
Error Relay
Error Relay
On Lockout, Blocking and Warning
On Lockout and Blocking
On Lockout
There are three possible selections to activate the Error Relay (alarm) contact:
On Lockout, Blocking and Warning: the error relay is activated at a non-volatile lock-
out (e.g. CH Flow NTC defect), at a blocking error (self-resetting errors) (e.g. Gas-pres-
sure switch not closed ), or at a warning (e.g. low water pressure warning).
On Lock-out and blocking: the error relay is activated at a non-volatile lock-out or a
blocking error.
On Lockout: the error relay is activated at a non-volatile lock-out only.
The selection depends on the alarm feedback requirement from the customer.
Boiler Settings
Prestige Model Solo (2 pumps)
Lockout Temp. 221°F [105°C]
Modbus Address 1
Pump settings
Ignition Level 3100rpm
Boiler Settings
Prestige Model Solo (2 pumps)
Lockout Temp. 105°C
Modbus Address 1
Pump settings
Ignition Level 3000rpm
Ignition Level NAT
3100rpm
1600rpm 6750rpm
This parameter allows to change the fan start speed of the appliance.
Press the LEFT or RIGHT buttons to adjust the settings, then on OK to validate your selec-
tion.
Default: See table below for each the fan speed applicable to each boiler/gas combination
Reset all settings
Reset All Settings
Reset All Settings
Press OK
to restore factory settings,
any other button
to keep current settings.
Reset All Settings allows the installer to reset all CH, DHW, and Cascade settings back to
the original factory defaults (Refer to page 6 for the factory settings). Follow the onscreen
instructions to reset all settings back to the original factory defaults.
Prestige Natural Gas (G20) Propane
24 Solo 3000 rpm 3000 rpm
24 Excellence 3000 rpm 3000 rpm
32 Solo 3500 rpm 3000 rpm
32 Excellence 3500 rpm 3000 rpm
42 Solo 3800 rpm 3350 rpm
50 Solo 3300 rpm 3300 rpm
75 Solo 3700 rpm 3000 rpm
100 Solo 2600 rpm 2600 rpm
120 Solo 2600 rpm 2600 rpm
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für ACV Prestige Solo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info