Bedienungsanleitung Ade BA 1405 Doreen (Seite 6 von 24) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

641791

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Thank you for purchasing these high-quality body analysis scales.

Please read these Operating Instructions carefully before using the product for the first

time, and keep them in a safe place so that you can consult them again if you need

further information.

1. How do body analyser scales work?

With these new revolutionary scales you will receive information on your body

composition regarding weight, percentage of body fat %, body water %, muscle mass

%, bone mass kg, BMI and your Basal Metabolic Rate (energy requirement) kcal.

To start, enter all the personal data, e.g. gender (male or female), age and height.

This information must be stored in your personal memory location just once. After that,

the process is as easy as on any regular scales. You only need to choose your individual

memory button, step onto the scales and in just a few seconds your current body status

will be displayed. A small electrical current is used to measure the resistance. Water,

which is mainly contained in muscles, is a good conductor, fat on the other hand blocks

the current. Taking the measured resistance and the stored data into consideration, the

body analyser scales can very precisely calculate your body composition.

2. Conditions of use

The measurements should take place without clothes, if possible, and always barefoot.

Since the body is subject to natural fluctuations (e.g. dehydration through sports or

sauna, intake of food and fluids), constant conditions should be ensured when

measuring, so as to receive comparable values.

Care should be taken that the measurements are always carried out at the same time of

day. Directly after getting up in the morning, the water has not yet spread through the

body. This means that the resistance is still relatively high, due to the bad conductivity in

the body. With increasing movements throughout the day, the water spreads through the

body, increasing conductivity, which causes the resistance, and thus the fat level too, to

be shown as lower. To determine the actual changes of body composition, it is therefore

important to measure always at same time. An easy way of doing this is by always

measuring a quarter of an hour after getting up in the morning, either before or after

using the toilet.

Despite the minimum current, persons with pacemakers or other implants, which

emit frequenc ies, must not use the body analyser scales! Other implants, e.g. a

titanium plate in the knee, pose no danger. Metals, however, conduct electricity

extremely well, which has the effect that body fat values are “beautified”, meaning that

the actual fat level is higher than shown by the scales. Tendencies, on the other hand,

can be determined just as well. In women, menstrual factors have an effect on the

measurement results, since hormonal fluctuations influence the body's water balance. If

the body contains all lot of water, the fat values are lower, if less water is contained the

7. Error messages

“Err” = Overload – The 180 kg maximum load capacity has been exceeded.

Remove the object from the scales immediately to avoid damaging the

scales' load cell unit.

Or: Faulty weighing / measuring process - For example, if the scales are

unstable or you are not standing still on the weighing platform.

“Lo” = Batteries low – Please replace with the appropriate battery type (4 x 1.5

V AAA).

“ErL” = Fat percentage % too low – lower than 5 % cannot be displayed.

“ErL” = Fat percentage % too high– higher than 50 % cannot be displayed.

8. Technical data

Load capacity x gradation: Max. 180 kg x 100 g

Display resolution: Percentage of body fat: 0.1 %

Display resolution: Percentage of body water: 0.1 %

Display resolution: Percentage of muscle mass: 0.1 %

Display resolution: Bone mass: 100 g

Pers. memory locations: 10

Age: 10 – 80 years

Height: 100 – 240 cm

Dimensions: approx. 350 mm x 300 mm x 23 mm

Batteries: 4 x 1.5 AAA (included)

Subject to technical changes

9. Warranty

ADE agrees to rectify any material or manufacturing defects by offering free repair or

replacement, for a period of 3 years from the purchase date. At the time of purchase,

please get the retailer to fill in and stamp the guarantee card. In the case of guarantee

claims, please return the scales to your retailer including guarantee card and stating the

reasons for the claim.

CE conformity. This device is interference-suppressed in accordance

with the applicable EU Directive 2004/108/EC

Note: Extreme sources of electromagnetic radiation, such as those caused by the

operation of radio equipment in the vicinity of the scales, can affect the value displayed.

The product will return to proper function as soon as the interference has been eliminated.

Note: the unit may need to be restarted.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ade BA 1405 Doreen Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info