Bedienungsanleitung Adler AD 1299 (Seite 4 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

799452

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Press“B” key once / twice / thrice / the fourth time, then the indicator light is under 60℃ / 70℃ / 80℃ / 90℃ condition with green / blue /

yellow / purple LED light. This means that it will stop heating when the water temperature reaches 60℃ / 70℃ / 80℃ / 90℃

Press the „A” key for 3 seconds, with the buzzer sends out „di” sound, it starts running the function of hest insulation. The LED light

will be shining with red light, while after the water boils, the kettle will keep the water temperature for 2 hours with the indiactor light

shining. Durning the 2 hours heat insulation function runnining, it will go on heating when the temperature arrives at 85 ℃

KEEP WARM FUNCTION 100℃

WATER BOILING 60℃ - 90℃

9. Regularly remove limestone sediment inside the kettle. Sediment may cause overheating of the kettle, shorten life cycle and

cancel guarantee. Use mixings available in household stores or apply citric acid.

4. After boiling water the kettle will automatically switch off.

29. Children aged 3 to 8 years old can enable and disable the device only when it is in

its normal position of use, they are supervised or instructed on the safe use and

understand the resulting risks. Children aged 3 to 8 years old can not connect device,

operate, clean or maintain.

DESCRIPTION

1. Fill the kettle with water. Make sure that heating plate is fully immersed in water.

8. After boiling, time demanded for the thermostat to be ready is 2 minutes. After this time kettle can be switched on again.

BASICAL OPERATION:

5 - base 6 - filter 7 - control panel 8 - tea infuser 9 - indicator lamp

SINGLE BOILING UP TO 100℃

After the water boils, indicator turns off and the buzzer sends out a “di” sound at the same time.

7. Keep lid closed during boiling process. Or the kettle won't automatically switch off.

11 When the water is heated to the appropriate temperature, device signals this with one beep.

2. Place the appliance on the flat, even and heat resistant surface.

1 - plastic lid 2 - handle for opening the lid 3 - housing 4 - handle

3. Plug the kettle to the 220-240V ~50/60Hz mains, press ON/OFF (A) switch. Indicator lamp will light.

BEFORE FIRST USE: Fill up the kettle with water, boil and pour. Repeat three times. To remove possible scent of manufactory,

please boil few times water.

USING THE ELECTRIC KETTLE

12. The kettle is an electrical device and it is not designed to hold water or other liquids. Before each use, fill the kettle with fresh

water above the minimum and below the maximum level.

10. Switching empty kettle, or with insufficient level of water, will cause automate switching off the kettle. Wait till cool down the

kettle, pour enough water and after few minutes switch the kettle on.

Press the “A” key briefly, with the sound “di.”, it starts working.

ADVANCED OPERATION:

6. The kettle can manually be switched off in any time by ON/OFF (A) switch.

5. Before taking the kettle out of the base make sure it is switched off.

kettle or lid. Do not open the lid during boiling in kettle or immediately after boiling,

because steam coming out of lid can cause burns.

21. Move the kettle only by holding it by handle..

23. Never switch on kettle without water.

22. Never fill kettle above MAX level and below MIN level. It may cause damage of

kettle.

25. Descale your kettle regularly. Using kettle with heating element covered by scale

may cause damage.

24. Never use kettle without filter or with open cover (automatic shutdown will not work).

26. Do not use aggressive detergents to wash the kettle housing - they can damage the

kettle or remove the markings.

27. The device is not designed to work with external schedulers or separate remote

control system.

28. Do not wash the base of the kettle directly in the water, just wipe with a dry cloth.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Adler AD 1299 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info