Bedienungsanleitung Adler AD 4082 (Seite 4 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

799915

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

C. Cover D. Bowl

21. Do not use the appliance to crush ice, bones or other hard products.

DESCRIPTION OF THE DEVICE

17. For safety reasons, only original accessories and spare parts should be used.

24. To clean the housing, do not use aggressive detergents, as they may remove the

applied graphic informational symbols such as: scales, markings, warning signs, etc.

25. THE MAXIMUM CONTINUOUS WORKING TIME OF THE CHOPPER IS 15 sec.

After 15 sec. continuous operation, wait 2 minutes before restarting it.

23. The appliance is not suitable for whipping eggs and kneading dough.

29. Always disconnect chopper from the power supply when it is left unattended and

before assembling, disassembling or cleaning.

15.Do not put your fingers or any other objects into the cup when the device is turned on.

A1. A2. On / off pulse buttons B. Motor unit

18. When removing accessories, handle the blades very carefully: they may injure.

19. Changes to the accessories may only be made when the device is switched off.

Before change disconnect device from the power supply.

26. If the blades become jammed, always unplug the power cord from the electrical outlet

before removing the blockage.

Contact professional electrician in this matter.

16. Make sure that long hair, scarves, ties, etc. do not hang over the cup and working

parts of the device.

20. Do not put anything other than food into the chopper bowl. Do not put hot products

and liquids (over 80°C) into the bowl.

27. Do not move nor lift the device while it is working.

22. Make sure the cover is properly fitted before turning power on the device.

28. Handle the blades carefully to avoid injury. Be careful when handling cutting blades,

when emptying the bowl and during cleaning.

2. Do not operate the device when the bowl is empty.

5. Place the motor unit (B) on the tip of the blades. Move it to fit the cover (C).

Assemble blades if necessary.

USING THE DEVICE:

Remove all protective elements and thoroughly clean the device before the first use.

3. Put ingredients into the bowl (D).

E1. Top set of blades E2. Lower set of blades

1. Do not operate the device continuously for more than 15 seconds, after this time leave it for 2 minutes to cool.

BEFORE FIRST USE

1. Place the bowl (D) on a flat and stable surface.

3. Do not pour hot liquids (over 80°C) into the bowl.

Place top set of blades (E1) on the shaft of the lower set of blades (E2).

Carefully move top set of blades (E1) clockwise until you hear “click” sound. To disassemble move top part (E1) anti-clockwise.

HOW TO ASSEMLBE BLADES

2. Place the blades (E1 and E2) on the guide pin in the bowl (D). Carefully push down the blades all the way down. Hold down and

spin to check if they are mounted correctly.

IMPORTANT NOTES:

4. Place the cover (C) on the bowl.

ATTENTION: Blades are sharp!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Adler AD 4082 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info