Bedienungsanleitung Adler AD 4496 (Seite 5 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

799976

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

heating mode to warm-keeping mode. Time on the display (3) will start counting down.

Time on the display (3) will start counting down after reaching the set temperature (2).

4. Fill the device with water to cover 3⁄4 of the highest jar with water. Do not exceed the maximum mark on the water tank (9).

After you finished using the product always remember to gently remove the plug from the power outlet holding the outlet with your hand.

Never pull the power cable!!!

1. Place e rack (10) on the bottom of device.

The device will now start to heat up, which can take up to 90 min.

6. After the set time has elapsed, the device automatically switches off and a signal tone sounds

7. Place the appliance in the sink or tub and drain the water by pressing the tap (6). Move the device only by holding it by handles (7).

Note: Set the temperature and time according to the cooking chart . The time indicated there is counted from the point at which the

desired temperature is reached.

2. Put on the lid (8), set the desired temperature by temperature control knob (1) max 100˚C and set the desired time by time control

knob(4) max 180 minutes, and then push the time control knob (1) when the desired temperature is reached, the device automatically

switches to keep warm mode. Time on the display (3) will start counting down.

The appliance can be used both for boiling food and for heating water, other liquids and pasteurization.

Once the set temperature is reached, the unit automatically switches from

10. After the appliance has cooled down, remove the jars with oven gloves as they will be hot for a long time. Allow the jars to cool

completely.

Heating liquids

After the set time has elapsed, the device automatically switches off and a signal tone sounds

5. Put on the lid (8) on the device and set the desired time by time control knob (4) and set the desired temperature by temperature

control knob (1) then push the temperature control knob (1).

3. Stir the drink regularly to distribute the heat evenly.

4. If you want to fill the drink, hold a cup under the tap (6) and push the tap down. When the cup is full release the tap (6).

Pasteurization.

Note: Do not use the tap when heating liquids with pieces of food (fruit punch, soup etc.) otherwise it will clog the tap.

Allow the appliance to cool down and remove the water.

To start the device, set the timer to 60 minutes by time control knob (4) and then push the temperature control knob (1).

Note: If you heat liquids, the device may be filled up to the maximum mark only. Failure to do so could cause liquid to leak when the

device is heated.

When the time has elapsed, the appliance switches off automatically.

1. Add the desired drink or water to the device.

2. Put up jars with food on the rack as shown in the illustration (B).

1.Allow the device to cool down completely before cleaning.

4. Wipe the case with a damp, soft cloth. Then wipe with a dry cloth.

2.Always unplug the appliance before cleaning.

3. Clean the bottom of the pot with a soft brush or a damp cloth. Never use sharp or hard objects to avoid damaging the surface .

Cleaning:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Adler AD 4496 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info