Bedienungsanleitung Adler AD 7725 (Seite 7 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

800023

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

14. Use this heater on a level and stable surface.

15. Always remove the plug from the socket after use by holding the socket with your hand.

DO NOT pull on the net cord.

16. Do not immerse the cord, plug or the entire appliance in water or any other liquid. Do

not expose the device to weather conditions (rain, sun, etc.)

17. Periodically check the condition of the power cord. If the power cord is damaged, it

should be replaced by a specialist repair facility in order to avoid a hazard.

18. Do not use the appliance with a damaged power cord, or if it has been dropped or

damaged in any way, or is not working properly. Do not repair the device yourself, as it may

cause electric shock. Return the damaged device to the appropriate service center for

inspection or repair. Any repairs may only be made by authorized service points.

Improperly performed repair may result in serious danger to the user.

19. Do not use the device near flammable materials.

20. Do not leave the device connected to the socket unattended.

21. For additional protection, it is advisable to install a residual current device (RCD) in the

electrical circuit with a rated residual current not exceeding 30 mA . Please consult an

electrician for this.

22. Do not allow the device to get wet. If the device falls into water, pull the plug out of the

socket immediately. Do not put your hands into the water when the device is connected to

the mains. It must be checked by a qualified electrician before being used again.

23. Do not handle the device with wet hands.

24. Before removing the plug from the socket, always turn off the device and turn the

thermostat knob to the minimum position.

25. The operating device must be supervised and within sight at all times. When leaving

the room where the device is operating, always turn it off. If the device is not working,

always remove the plug from the mains socket.

26. Do not cover the device during operation, nor place any objects on it.

27. The power cord must not be laid above or below the heater, nor should it touch or lie

near its hot surfaces. Do not place the device directly under an electrical outlet.

28. Heating surfaces may heat up to more than 60°C. The device should be installed in

such a place that children and pets cannot reach it.

29. The device may not be installed or used in vehicles.

30. There are parts inside the appliance that may be hot or cause sparks. Do not operate

the heater in areas where materials such as gasoline, paint or other flammable substances

are used or stored.

31. Always disconnect the device from the mains and disconnect the power cord from the

device when it is not in use or you want to clean it.

32. The fan heater is equipped with an overheating protection device that will automatically

turn off the heater if the temperature inside the device is too high. This may be due to

clogged vents or a fan not working properly. In this case, it is necessary to disconnect the

device from the power supply, wait a few minutes and remove the cause of overheating. If

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Adler AD 7725 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info