Bedienungsanleitung Adler AD 9617 (Seite 4 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

800094

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

10. Do not use the device on clothes you are wearing, always take them off. This may

cause personal injury or damage to the lint remover.

11. The device has a protective lock. It will not function unless the blade cover is reﬁtted.

12. Take care not to use the device on buttons, zips, appliqués, patches, stickers, labels,

rips, seams, and seams.

13. Do not use the device on silk, wool, or linen garments. This can damage fabrics and

damage the shaver blades.

14. Do not use the device near water, e.g. in the shower, bathtub, or over a wash basin

with water.

15. Do not allow the device to get wet. Before using the appliance again, it must be

checked by a qualiﬁed electrician.

9. Do not press the device into the fabric as this may damage the fabric.

16. Do not handle the device with wet hands.

11. Cleaning brush 12. USB charging cable

5. USB type C charging port 6. Blade Cover

1. Battery level indicator 2. Battery charging indicator

9. Bin for knots and pilling 10. Housing

17. The device should be turned off each time it is put away.

Device description:

3. Working speed indicator 4. Button for changing the working speed / ON OFF power

7. Blades 8. Rotary shaft

BATTERY CHARGING:

When the battery is fully charged, the battery level indicator will show 100%. The time to fully charge the battery is 2-3 hours. When fully

charged, the run time is approximately 120 minutes, depending on the selected speed.

1. Place the garment (fabric) on a ﬂat surface, and smooth out the wrinkles.

When connected to power, the battery charge indicator (2) will illuminate and the battery charge indicator (1) will display the current

battery charge.

USING THE DEVICE

2. Switch on the device by pressing the button (4), the device has three speeds. To increase the speed, press button (4) again. Available

speeds: 6500, 7500, 8500 rpm

4. Stubborn knots can be removed by moving the device across and then along ("checkered") on one small piece of clothing.

5. Thin garments can be defrosted by placing them on ﬂat, rigid cardboard.

3. Move the device back and forth across the material.

6. For fabrics with a pattern, move the device in the direction of the pattern.

CLEANING

The device should not be used while charging.

1. Switch off the device by pressing the button (4).

To start charging, plug the charging cable (12) into the charging socket (5) and then connect it to the power supply.

6. After cleaning, reassemble all the disassembled parts.

5. Empty the knots and lint container (9).

The device has a protective lock. It will not function unless the blade cover (6) is reﬁtted.

Power: 5W

Power supply: USB 5V/1A

3. Remove the blades (7) by pulling them upwards (Caution! The blades are very sharp!).

TECHNICAL DATA:

2. Unscrew the blade protection cover (6) counter clockwise.

4. Clean the blade cover (6), the blades (7), and the rotating shaft (8) with the included brush (11).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Adler AD 9617 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info