661824
161
Zoom out
Zoom in
Vorherige Seite
1/275
Nächste Seite
156
Applying transitions and special effects
Last updated 10/4/2016
Bass
The Bass effect lets you increase or decrease lower frequencies (200 Hz and below). Boost specifies the number of
decibels by which to increase the lower frequencies.
AudioGain
Audio gain helps in normalizing audio, by either raising or lowering it to match other audio sources.
Channel Volume
The Channel Volume effect lets you independently control the volume of each channel in a stereo clip or track. Unlike
the Balance effect, Channel volume doesn’t automatically reduce the volume of one channel when you raise that of the
other. You might use this, for example, to raise the volume of a voice in the left channel without diminishing the volume
of a voice in the right. Each channels level is measured in decibels.
Delay
The Delay effect adds an echo of the audio clips sound that plays after a specified amount of time.
Delay Specifies the amount of time before the echo plays. The maximum is 2 seconds.
Feedback Specifies a percentage of the delayed signal to be added back into the delay to create multiple decaying
echoes.
Mix Controls the amount of echo.
DeNoiser (Windows only)
The DeNoiser effect automatically detects tape noise and removes it. Use this effect to remove noise from analog audio
recordings, such as magnetic tape recordings. Click the triangle beside the Custom Setup button to view the following
options:
Freeze Stops the noise floor estimation at the current value. Use this control to locate noise that drops in and out of a
clip.
Reduction Specifies the amount of noise to remove within a range of -20 to 0 dB.
Offset Sets an offset value between the automatically detected noise floor and the value that you specify. This is limited
to a range between -10 and +10 dB. Offset allows additional control when the automatic denoising is not sufficient.
Dynamics (Windows only)
The Dynamics effect helps eliminate unwanted background noise, balance the dynamic range, and reduce clipping, or
the distortion from over-amplification. Click the Custom Setup twirl-down triangle to open the following controls:
AutoGate Specifies the level (in dB) that the incoming signal must exceed. Signals below this level are muted. Use this
control to remove unwanted background noises, such as a background noise behind a voiceover.
Compressor Sets the level (in dB) at which compression occurs and the ratio at which compression is applied, up to
8:1. Also controls the attack time (the time it takes for the compressor to respond), the release time (the time it takes for
the gain to return to the original level when the signal falls below the threshold). The MakeUp control adjusts the output
level to account for loss in gain caused by compression. Use the Compressor controls to increase the volume of soft
sounds, decrease the volume of loud sounds, or both.
Expander Reduces all signals below the specified threshold to the specified ratio. The result is similar to the Gate
control, but subtler.
Limiter Sets the maximum level for signals, between -12 and 0 dB. Signals that exceed the threshold are reduced to the
threshold level.
161

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Adobe Premiere Elements 15 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info