Bedienungsanleitung Aduro 12 (Seite 29 von 49) (Deutsch, Englisch, Dänisch, Französisch, Schwedisch)

632339

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

_______________________________________________________________________________________________________________________________

4.8.1 How to operate Aduro-tronic

When lighting

When lighting a fire in the wood burning stove for the first time, the

maximum amount of primary air will be needed to light the fire. For that

reason, the primary damper can be kept “forcibly open”. This is done

by pulling the primary damper forward as far as possible and then

fixing it with the Aduro Key (see illustration). When the stove is warm

and a layer of embers has been created on the bottom of the

combustion chamber, the Aduro-tronic can be set to the automatic

position, i.e. the Aduro Key can be removed.

Alternatively, you can leave the door ajar the first minutes during

lighting the fire (without the key).

When stoking

Each time fresh wood is put in the stove, a precise amount of primary

air will be allowed in for the first few minutes. What’s more important is

that the primary air is not allowed in for too long. This is to ensure

optimum combustion. The Aduro-tronic control will ensure intake of

primary air at the right tempo. The automatic is activated by pulling the

primary damper out each time fresh wood is put in the stove. The

automatic closes then the primary air gradually.

Regulation of the Aduro-tronic control

The control is pre-set to allow primary air intake for the first 5 minutes. This setting has been used during testing at

the Danish Technological Institute using ‘standard’ sized logs and with optimum moisture content of 17%. Standard

size logs are approx. 30 cm long and 10 x 10 cm in thickness. A standard chimney was also used for testing. In

practice, such circumstances can differ, which is why the Aduro-tronic control can be adjusted to your

circumstances. If you want a slower intake of primary air: (e.g. for a slower flue draught, larger sized wood or for

longer intervals between stoking) Adjust the screw on the front of the control level using a small allen key to slow

closure rate. If the screw is turned to the right closing time is increased and if turned to the left closing time is

reduced. The Aduro-tronic must be closed within 10 minutes.

4.9 Ventilation/fresh air supply

In order for the wood burning stove to function at optimum efficiency, air is needed for the combustion process.

There must be sufficient fresh air coming into the room containing the wood burning stove. In very well-insulated

houses, or houses with powerful cooker hoods and/or air conditioning systems, a vacuum can be created around

the wood burning stove, leading to smoke leakage and poor combustion. In these circumstances, it might be

necessary to open a window to provide air for combustion and to equalize the vacuum. Alternatively, you could fit

an air vent in the room containing the wood burning stove. The amount of air needed for combustion is 25 m

/h.

5.0 The chimney

Data for chimney calculation:

Wood

Flue temperature at [20 C]

279

Chimney draught at testing power

[mbar]/[Pa]

0.12/12

Flue gas mass flow [g/s]

4.11

The optimum combustion is achieved at a constant chimney draught of 0.10 to 0.14 mbar measured in the flue pipe

above the stove. There are many factors that affect the chimney draught, including the outside temperature, wind

strength and surrounding buildings. If it is impossible to establish a sufficiently natural chimney draught, the

chimney can be fitted with a smoke extractor. If the chimney draught is too strong, a damper can be fitted to

regulate the chimney draught. Contact your local chimney sweep for more advice.

There are no requirements with respect to specific chimney heights, but a chimney must be tall enough to provide a

good draught – above 12 Pa. If the recommended chimney draught is not achieved, there may be problems with

smoke out of the door by firing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aduro 12 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Aduro 12

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info