Bedienungsanleitung Aduro 15 (Seite 25 von 46) (Deutsch, Englisch, Dänisch, Französisch, Schwedisch)

632341

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

_______________________________________________________________________________________________________________________________

exceed 18 %, which roughly corresponds to storing the wood under cover outdoors for one year. The moisture

level of the wood can be measured using a moisture meter or by applying washing up liquid to one end of the

log and blowing air in the other end. If the wood is dry enough, soap bubbles will appear. The wood should be

chopped into logs with a diameter of approx. 10 cm and a log length of max. 50 cm.

Correct firing provides optimal heat output and maximum economy. At the same time, correct firing prevents

environmental damage in the form of smoke and malodorous fumes and also reduces the risk of chimney fires.

Well seasoned wood fuel is essential for correct use. Make sure your fuel is kept dry. If the fuel is wet, a large

proportion of the heat will be used to vaporize the water, and this energy will disappear up the chimney. It is

clearly not only uneconomical to fire with wet fuel but also, as mentioned above, increases the risk of producing

soot, smoke and other environmentally damaging by-products.

Burning varnished wood, impregnated wood, chipboard, paper and other waste is strictly forbidden. Burning these

materials will damage the environment, the wood burning stove and your own health. Fossil fuels must not be

used.

3.3 How do I light a fire in the wood burning stove?

The fire lighting method is very important for starting combustion quickly and efficiently.

1) Open the primary air intake/damper under the door and open the secondary air intake behind the door. The

primary damper is used at the start to get the fire going, while the secondary air intake keeps the fire

burning evenly. The secondary air intake is closed when the damper is pushed all the way to the left and

open when the damper is pushed to the right. To open the primary air intake the damper should be pulled

out. The illustration below shows the stove seen from the front with the dampers indicated.

2) Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log. Light the

firelighters and quickly put a new log close to the firelighters and several small logs at an angle above it. Air

must be able to reach the firelighters, but the logs should be touching to “warm” each other.

3) Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there are

distinct, visible flames and the fire has taken hold, close the primary air intake/damper.

Important: The control handle will get warm when the wood burning stove is being used. Please use the glove

provided when you operate the wood burning stove.

3.4 The first time a fire is lit

The wood burning stove is packed in recycling packaging (wood and plastic). This must be disposed according to

Secondary air intake

Primary air intake

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Aduro 15 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Aduro 15

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info