Bedienungsanleitung AEG 97141 (Seite 6 von 20) (Deutsch, Englisch, Französisch, Italienisch)

574011

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

GB | 5

Damages resulting from improper handling, ignoring the instruction manual or intervention by unauthorized

personal are excluded from liability. Do not open the daytime lights. Repairs are to be carried out by qualified

service personnel only.

Installation- and Warning Instructions

• Before assembly check whether the installation depth behind the bumper/cooler grid is sufficient, never

reduce cool air feed for brakes or intercooler, respectively damage hoses, electrical cables or stabilising

struts.

• Daytime lights illuminate automatically as soon as the ignition is switched on and as long as the head lights

(parking, head, fog or full beam lights) are switched off. Rear lights are not allowed to shine in Germany

when daytime lights are switched on.

• Strictly observe the installation dimensions and the legal regulations.

• Please observe the safety instructions and requirements specified by the manufacturer and motor vehicle

trade.

• If you are not familiar with the car electrics, we recommend the installation be carried out by a qualified

garage or a garage authorized by your car manufacturer.

• Always disconnect the minus and plus pole of your car battery when working on the car electrics, because

short circuits could result when installation errors occur.

• If the car has additional batteries, disconnect them also from the car electrics.

• Possible short circuits can damage or destroy components or electronic systems (airbag, engine control

systems etc.).

• After disconnecting the minus pole respectively plus pole from the battery, all volatile electronic memories

such as board computer, time switches and radios lose their stored values. Therefore please note the radio

code before installation.

• Please point out to the customer when handing over the vehicle that he might have to re-program the data

for e.g. the seat position, cruise control, time switch or auxiliary heating.

• The manufacturer checks continuously, if the compliance of the product is kept to the latest requirements.

The manufacturer of this system does not however accept any liability for damages caused by faulty instal-

lation or improper operation.

You will find the installation instructions with diagrams at the end of the instructions

Maintenance and Care

Maintenance for daytime lights is not necessary. To clean the diffusion plate, please use a wet cloth without

aggressive cleaning agents.

Information on disposal

Please dispose of the packaging and electric components environmentally friendly. According to

EU guidelines 2002/96/EC for electrical and electronic waste and transition into national law,

old electronic devices have to be collected separately and recycled environmentally friendly.

Please contact your local authorities about the disposal possibilities of old electronic devices.

Technical Data

Operating voltage: 12/24 V DC

Capacity: 7 W

Type of bulb: 2 x 18 High Performance LED

Temperature range: - 25 – + 85 °C

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG 97141 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info