Detach the mounting sleeve (D) and frame (B) from
the unit housing. Use the assembly keys (C) to do so.
Fit the mounting sleeve into the ISO dashboard slot.
Bend the mounting sleeve tabs round with a screw-
driver so that the frame is mounted securely in the
dashboard slot.
Check that the frame is secure.
Connect the ISO connection of the unit to the two ISO
connectors of your vehicle.
Connect the antenna cable of the vehicle antenna to
the antenna adapter of the unit.
If necessary, also secure your unit against theft.
Fasten the screws to the mounting bracket and to the
mounting material on the engine rewall of the car.
Slide the unit carefully into the mounting sleeve, until
it clicks into place.
After all connections have been made, press the
RESET
button (26) using a ballpoint pen or other pointed
object.
Attach the control panel (A), as described under
„Attach control panel“.
CAUTION:
Possible damage to the cables!
When inserting the unit, pay attention to the cable
►
routing to prevent damage.
Then mount the frame.
Disassemble the unit
To disassemble the unit, proceed as follows:
Remove the frame.
Insert the right and left hand assembly key into the
respective slots on the sides of the unit. (The tabs are
now bent back.)
Pull out the unit.
NOTE:
If the housing is uneven, the tabs on the mounting
►
sleeve may become jammed. Use the assembly keys
to release the tabs.
Installation for Toyota or Nissan
NOTE:
Mounting sleeve, frame and mounting strip are not
►
required.
Use the threaded mounting holes on the sides of the unit
(A), to fasten the unit to the mounting brackets (supplied
with your vehicle). The holes are labeled T (for Toyota) or
N (for Nissan).
