Bedienungsanleitung AEG AXP26U558HW (Seite 21 von 92) (Deutsch, Englisch, Holländisch, Französisch)

688861

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

ENGLISH

Drain the water collection tank

completely and leave the bottom

drain cap and rubber plug long time

enough to allow any residual water to

drain out. Once the tank is completely

drained and no more water ows out,

reinstall the rubber plug and cap.

Make sure the lter and drain cap are

in place.

Check the cord to make sure it is in

good condition, without cracks or

damage.

Place new batteries in the remote

control.

Install the air conditioner as described

in the Installation Instructions.

Wash the lter using liquid

dishwashing detergent and warm

water under 40°C. Rinse lter

thoroughly. Gently shake excess

water from the lter. Be sure lter is

thoroughly dry before replacing. Or,

instead of washing you may vacuum

the lter clean.

Replace the lter after the lter is dry.

Be sure lter is thoroughly dry

before replacing.

If the air conditioner will not be used for

an extended period of time:

Before using the air conditioner again:

8.3 Winter Storage

TROUBLE SHOOTING

Before calling for service, review this

list. It may save you time and expense.

This list includes common occurrences

that are not the result of defective

workmanship or materials in this

appliance.

Air conditioner will not operate.

Air from unit does not feel cold enough.

Air conditioner cooling, but room is

too warm - NO ice forming on cooling

coil behind decorative front.

• Wall plug disconnected. Push plug

rmly into wall outlet.

• House fuse blown or circuit breaker

tripped. Replace fuse with time delay

type or reset circuit breaker.

• Control is OFF. Turn Control ON and

set to desired setting.

• Fault code P1 appears in the display

window. Drain water as described in

7.3 Drainage Section.

• Room Temperature lower than the set

temperature (Cool Mode) or Room

Temperature higher than the set

temperature (Heat Mode). Reset the

temperature.

• Room temperature below 16°C.

Cooling may not occur until room

temperature rises above 16°C.

• Reset to a lower temperature.

• Compressor shut-o by changing

modes. Wait approximately 4 minutes

and listen for compressor to restart

when set in the COOL mode.

• Outdoor temperature below 16°C.

To defrost the coil, set Fan mode.

• Air lter may be dirty. Clean lter.

Refer to 8. Care and Cleaning section.

To defrost, set to Fan mode.

• Temperature is set too low for nighttime

cooling. To defrost the coil, set to Fan

mode. Then, set temperature to a higher

setting.

• Exhaust duct not connected or blocked.

See 5.1 Exhausting hot air Section.

Remove and clean the lter, allow it

to dry completely, then reinstall it.

Remove the batteries from the

remote control.

Store the air conditioner in a cool,

dry location, away from direct

sunlight, extreme temperature,

excessive dust, and well ventilated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG AXP26U558HW Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info