Bedienungsanleitung AEG BS7304701 PRO COMBI (Seite 44 von 52) (Englisch)

639419

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Remove the baking tray after the end of

the procedure.

12.7 Steam Cleaning - S2

Remove as much dirt as possible

manually.

Remove the accessories and the shelf

support to clean the side walls.

The steam cleaning functions support

the steam cavity cleaning of the

appliance.

For a better performance

you should start the cleaning

function when the appliance

is cool.

The specified time is related

to the duration of the

function and does not

include the time required for

cleaning of the cavity by the

user.

When the steam cleaning function is

active, the lamp is off.

1. Fill the water drawer to the maximum

level (around 950 ml of water) until

the acoustic signal sounds or the

display shows the message.

2. Activate Steam Cleaning function -

S2. Refer to "Activating a cleaning

function".

The duration of the function is

around 30 minutes.

An acoustic signal sounds when the

programme is completed.

3. Touch a sensor field to deactivate

the signal.

4. Wipe the internal surface of the

appliance with a non-abrasive surface

care sponge. You can use warm

water to clean the cavity.

After cleaning keep the appliance door

open for approximately 1 hour. Wait until

the appliance is dry. To speed up the

drying you can heat up the appliance

with hot air at temperature 150 °C for

approximately 15 minutes. You can get

maximum effects of the cleaning function

if you manually clean the appliance

immediately after the function ends.

Repeat the procedure a second time if

the level of dirt is high.

12.8

Cleaning Reminder

This function reminds you that the

cleaning is necessary and that you should

perform the function: S2.

You can enable / disable this function in

the settings menu.

12.9 Steam generation system

- Descaling - S3

When the steam generator operates,

there is an accumulation and deposition

of limestone inside because of calcium

contents in the water. This can have a

negative effect on the steam quality, on

the performance of the steam generator

and on the food quality. To prevent this,

clean the steam generation circuit from

residual stone.

Select the function from the menu: .

The duration of the complete procedure

is about 2 hours.

The light in this function is off.

1. Remove all accessories.

2. Make sure that the water drawer is

empty. Activate Tank Emptying - S1

function if needed.

3. Put the grill- / roasting pan on the

first shelf position.

4. Put 250 ml of the descaling agent in

the water drawer.

5. Fill the remaining part of the water

drawer with water to the maximum

level until the acoustic signal sounds

or the display shows the message.

The duration of the procedure is

about 1 hour 40 minutes.

6. Activate Descaling function - S3.

Refer to "Activating a cleaning

function".

7. After the end of the first part, empty

the grill- / roasting pan and put it on

the first shelf position again.

8. Activate the Rinsing function. Refer

to "Steam generation system -

Rinsing - S4".

Remove the grill- / roasting pan after the

end of the procedure.

www.aeg.com

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG BS7304701 PRO COMBI Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von AEG BS7304701 PRO COMBI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info