Bedienungsanleitung AEG CAFAMOSACF90 (Seite 7 von 18) (Englisch)

557726

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Do not open or repair the appliance.

Improper repairs can give rise to signif-

icant hazards for the user.

Repairs to electrical appliances are only

to be performed by qualified service

engineers.

In the case that repair becomes neces-

sary, including the replacement of the

mains lead, please contact

• the dealer from whom you purchased

the appliance, or

• an AEG customer service centre.

In no circumstance should the appli-

ance be sent by post - there is a risk of

transport damage that cannot be cov-

ered under the guarantee!

If the appliance is used for a purpose

other than that intended, or is incor-

rectly operated, no liability for any

resulting damage or claims under the

guarantee can be accepted - this is also

the case if the cleaning and descaling

programs are not performed immedi-

ately after the illumination of the cor-

responding indicators (Figure 2), and in

accordance with the information given

in these operating instructions.

;

This appliance complies with the fol-

lowing EC directives:

• 73/23/EWG dated 19.02.1973 “Low

Voltage Directive“, including Directive

Amendment 93/68/EWG

• 89/336/EWG dated 03.05.1989 “EMC

Directive“, including Amendment

Directive 92/31/EWG

1. Before Using for the First Time

1.1. Setting Up the Appliance

Choose a suitable, level, stable,

unheated, dry surface. Pay attention to

adequate air circulation.

Important: If the appliance is placed in

a warm room after being brought in

from the cold - wait approx. 2 hours

before switching on the appliance!

1.2. Cable compartment (Figure 3)

Your appliance has a cable compart-

ment on the rear. If the mains lead is

too long, you can push the cable that is

not needed into the cable compart-

ment.

1.3. Adjusting the Water Hardness

Your appliance can be adjusted to the

hardness of the water used. The correct

adjustment of the water hardness is

necessary for the correct function of

the automatic scaling indicator (see

also Section 9.).

Use the Aquadur® test strips supplied

to determine the hardness the local

water. Follow the instructions given on

the test strip packaging. Or: Ask your

water board about the hardness of

your water!

The appliance has 5 hardness settings,

the appliance is set to the middle set-

ting, 3, in the factory (corresponds to

16°-23° degrees German hardness).

You can change this setting as follows:

0 Plug the appliance into the mains.

0 Do not switch on the appliance.

0 Press the “1 Cup“ button for

approx. 3 seconds. The “Descale“

indicator flashes.

Pressing the “1 Cup“ button again

changes the water hardness setting by

one step to 4, 0, 1, 2, 3, and so on.

0 To store the water hardness setting and

to end the procedure, press the

“On/Off“ button. All indicators go out.

If a button is not pressed for more than

30 sec., the procedure is automatically

ended without changing the value

saved previously.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG CAFAMOSACF90 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von AEG CAFAMOSACF90

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info