Bedienungsanleitung AEG DBS 5532 (Seite 36 von 62) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

551729

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

English

CAUTION: INITIAL USE:

Please proceed as follows:

• The tank should only be  lled up to the maximum

mark. Do not over ll!

• If there is any residual water in the tank, we recom-

mend that you do the following:

• Continue ironing with steam until the control

lamp (5) shows that there is not enough

water and no further steam comes out of the

soleplate of the iron. Then  ll up the water tank

as instructed (see under „How do I  ll in water

during operation“).

or:

• Pour the residual water into a measuring cup

and  ll it with distilled water up to the maxi-

mum mark of the tank (0.7 litres).

• Close the water tank.

• Connect the base station to a 230 V / 50 Hz socket

with earthing contact.

• Turn the switch (4) on the base on.

• Set the desired temperature within the range „• •“

to „• • •“.

• Please wait until the control lamp (6) on the base

lights up.

• Now press the steam jet button (12) for at least

1 minute or use the bar (13) to lock the steam jet

button in place.

ޥ NOTE:

• This time is needed for the steam to reach the

iron.

• Keep a cloth ready! During this phase water

also comes out of the soleplate of the iron.

• When only steam comes out without any water

you can stop the procedure. Then press the steam

jet button another 2-3 times without touching the

clothes that are to be ironed.

• After you have ironed an old but clean cloth a few

times, your station is ready for use.

• In order to regulate the steam quantity, please use

the steam regulator (7).

• When ironing at low temperatures, please ensure that

you do not use any steam. If the temperature is too

low water may leak from the soleplate.

Vertical Steam

This can be used to produce a jet of steam in a vertical

direction.

Hang your laundry on a clothes hanger and move the

iron to approximately 2-3cm away.

How can I replenish the water during operation?

If the pressure falls during operation you can  ll more

water into the tank at the same time. Re ll with water

before the tank is completely empty. The lamp (5) shows

that there is not enough water.

• If you have been using the permanent steam func-

tion, release the bar (13).

• Turn the switch (4) on the base o .

ޥ NOTE:

If there is still some residual pressure in the water

tank, a safety lock prevents the water tank catch

(10) from being opened.

WARNING:

The residual pressure  rst has to be relieved

before the device can be safely opened.

• With the steam jet button (12) you can now release

the residual steam pressure. If no more steam comes

out of the soleplate, please remove the plug and

release the water tank lock (10) carefully.

WARNING:

• The steam is hot! There is a danger of scal-

ding!

• Do not touch the hot iron!

ޥ NOTE:

If it is not yet possible to open the lock of the wa-

ter tank the device needs a further 2 to 3 minutes

to cool down. Then release the residual pressure

again.

• Fill the tank with the help of the funnel. Do not

over ll! Take care of water splashes that might come

out of the boiler. In order to avoid water splashing

out, the water should be  lled into the funnel after

the safety lock has been opened and the iron allowed

to cool down for about 1 to 2 minutes.

• Close the water tank.

• Continue ironing.

ޥ NOTE:

Keep a cloth ready! At  rst water may also be expelled

from the soleplate of the iron.

WARNING:

Never open the water tank lock while the device is

being operated.

When you have  nished

• Now you can start ironing. Always turn the tempera-

ture control to „0“ after use and remove the mains

plug (the control lamp in the handle goes o ).

• Turn the switch (4) on the base o .

• Remove the mains plug from the socket.

• Keep the plug in your hand.

• Press the cable winding button (8) and guide the

cable. Hold the cable to avoid wrapping.

• Allow the device to cool down before you put it

away.

05-DBS 5532.indd 3605-DBS 5532.indd 36 16.02.2009 9:33:27 Uhr16.02.2009 9:33:27 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG DBS 5532 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info