Bedienungsanleitung AEG DBS3360 (Seite 6 von 48) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

689108

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

6www.aeg.com

ENGLISH

Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories

and spare parts. They have been designed especially for your product. This product is designed with the

environment in mind. All plastic parts are marked for recycling purposes.

Dear Customer,

It may be possible that your steam station does not produce steam immediately after lling it with water for the

rst time or relling the tank. The reason for this is that air trapped in the inner system can delay this function a few

seconds. Please be patient and try it again by pressing the steam button. For your convenience the steam will appear

after you release the steam button for a few seconds and it is not necessary to press the button all the time. Find out

your rhythm for the best steaming result. Thank you for your kind attention and please enjoy your new steam station!

COMPONENTS

A. Steam button

B. Soft handle

C. Temperature alignment mark

D. Temperature selector

E. Temperature indicator light

F. Hot water pipe

G. Mains cable

H. Base unit

I. Anti-calc cartridge

J. Water tank

K. Maximum water level indicator

L. Stainless steel soleplate

M. Iron rest

N. Power indicator light

O. Descaling indicator light

P. Low level water indicator light

Q. Steam level indicator light (Low, Medium, High)

R. Rell reset button

S. Power button

T. Steam level control button

Picture page 2-3

GETTING STARTED

1 Before rst Remove all adhesive remains and gently rub with a dampened cloth. Position the steam gen-

erator iron horizontally on the ironing-board or on a heat resistant, secure surface at the same height as an

ironing-board. Unwind and straighten the power cord and the steam cord. When turned on for the rst time,

temporary vapours/odours may occur.

2 Remove the water tank by gripping the slot on the underside and pulling it gently away from the base unit. (A)

Detach the anti-calc cartridge and then immerse it in water for more than one minute. (B) Insert the anti-calc

catridge back. Fill the water tank using cold water. It is recommended to use destilled water or a mix of 50%

destilled, 50% tap water. Empty the water tank to rinse out any foreign particles which may remain from the

manufacturing process.

3 Always rell the water tank to MAX level using cold water (A). Insert the water tank into the base unit (B). It is

recommended to use destilled water or a mix of 50% destilled, 50% tap water. Ensure that the water tank latches

securely into place.

4 Connect the steam generator iron to the mains supply. Press the power button (A). Turn the temperature selec-

tor clockwise to maximum setting (B). The temperature indicator light on the iron will illuminate. Then, select a

steam level on the control panel, from low - medium - high steam.

5 When the temperature indicator light turns on, the steam station is pre-heating. When the light turns o, it

is ready to be used. Press and hold the steam button for about one minute to get steam. Then hold one more

minute in order to clean the steam generating system.

6 Iron an old towel, to ensure that any residues inside the iron are not transferred to the laundry. If necessary, wipe

the sole plate with a slightly damp cloth.

OPERATING INSTRUCTIONS

7 Connect the steam generator iron to the mains supply. Press the power button. When the power switch is

pressed, the power indicator will illuminate. Wait for one to two minutes, until the steam lamp lluminates. Select

the steam level between Low - Medium and High. See Ironing chart for ironing recommendation.

8 If the lower water level indicator is illuminated (A) (followed with two beep sounds), rell the water tank. After

relling the water tank, press the rell reset button (B). The rell reset button will be extinguished. Steam can

now be used again.

9 To activate the steam, press the steam button. When releasing the button, use up the steam before putting it

back on the iron rest of the steam station.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG DBS3360 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info