Bedienungsanleitung AEG DDLE OKO TD 18 (Seite 29 von 100) (Deutsch, Englisch)

648347

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Operation – for users and qualied contractors

4.5 Recommended settings

4.5.1 Energy saving

You will consume the least amount of energy with the

following recommended settings:

◦ 38 °C for basins, showers, baths,

◦ 55 °C for sinks.

4.5.2 Thermostatic valve

If you operate the appliance with a thermostatic valve,

we would recommend that you set the temperature at the

appliance to the maximum level (temperature selector at

60 °C). You can then select the required temperature at

the thermostatic valve.

5. Maintenance and care

A damp cloth is sufcient for cleaning the casing. Never

use abrasive or corrosive cleaning agents.

6. What to do if ...

6.1 ... the water supply is interrupted

Risk of damage!

After an interruption to the water supply, take the

following steps prior to returning the appliance

into use.

» Remove fuses or trip the appropriate MCBs.

» Open a draw-off valve, downstream of the appliance,

long enough to vent all air from the appliance and its

upstream cold water supply line.

» Replace the fuses or reset the relevant MCBs.

6.2 ... the wireless remote control batteries

are spent

Fault Cause Remedy

LED on wireless

remote control flashes

during and after

sending.

Batteries in the

wireless remote

control spent.

Replace batteries.

» Open the wireless remote control casing by undoing

the two screws at the back and pivoting the casing

open.

» Remove the old battery and insert the new one.

Ensure correct polarity of the new battery: Posi-

tive (+)

must be at the top. Observe the information in chap-

ter "Environment and recycling".

» Close the casing. Observe the casing recess in the

edge of the lid. The recess determines the correct

positioning of the lid and ensures the casing is tightly

sealed.

6.3 ... faults occur on the appliance?

Fault Cause Remedy

The heating system

will not start in spite

of the tap being fully

open.

No voltage.

Check the fuse/MCB

in your fuse box/

distribution panel.

Low flow rate, shower

head/perlators scaled-

up.

Clean and / or descale

perlators.

Heating system faulty. Call customer service

/ your contractor.

Cold water flows

briefly.

The air sensor detects

air in the water and

briefly switches the

heater OFF.

Appliance starts again

after one minute.

Flow rate too low.

ECO mode is enabled,

and the throughput in

ECO mode is set too

low.

Select a higher ECO

throughput.

Shower head/

perlators scaled-up.

Clean and / or descale

perlators.

Temperatures above

43 °C cannot be

selected.

Dynamic anti-scalding

protection is enabled.

Cancelled

automatically 2

minutes after drawing

has ceased.

Where a fault can only be remedied by a contractor, they

can better and more speedily remedy the fault if you pro-

vide them with some of the details from the type plate (19):

26_02_02_0883

DDLE ÖKO TD Nr.: . . . - . . . . - . . . . . .

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG DDLE OKO TD 18 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info