Bedienungsanleitung AEG DDLT PinControl 24 (Seite 18 von 124) (Deutsch, Englisch, Holländisch, Französisch, Polnisch, Türkisch)

648360

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

Operation - for users and contractors

2.3 Test symbols

See type plate on the appliance.

Country-specic approvals and certications:

Germany

A general test certicate as verication of suitability re-

garding noise emissions has been issued for this appli-

ance, based on the State Building Regulations [Germany].

AEG

HOL

DIN 4109

PA-IX 6817/I

3. 

The hydraulically controlled instantaneous water heater

heats water as it ows through the appliance. When a tap

is opened, the heating output starts automatically as soon

as the start-up volume is exceeded (see chapter "Speci-

cation / Data table"). The water volume and temperature

can be adjusted at the tap.

You can choose between 2 output stages. In addition, 2

output stages are hydraulically controlled in relation to the

ow rate.

The ow rate controller compensates for pressure uc-

tuations, thereby ensuring largely stable temperatures.

The controller limits the throughput, thereby ensuring an

adequate increase in the DHW temperature at all times.



The bare wire heating system has a pressure-tested plas-

tic casing. The heating system is suitable for hard and soft

water areas and is largely insusceptible to scale build-up.

This system ensures rapid and efcient DHW availability.

4. Settings

26_02_02_0783

2 1

1 Partial load

At low throughput 1/3 of the heating output is activat-

ed; at higher throughput 2/3 of the available heating

output is enabled. This setting is suitable for hand

washing at a basin, for example.

2 Full load

At a low throughput, 50 % of the heating output is ap-

plied; at a higher throughput the full heating output is

activated. This setting is suitable for washing dishes,

for example.

» Click the output selector into the required position.





» Set the output selector to full power.

4.1 

Note











» 

Low draw-off rate = high outlet temperature

High draw-off rate = low outlet temperature



 

Partial load Washbasin

Full load Bath, shower, sink

» Add cold water if the temperature is too high when

the tap is fully open.



 

Full load All

» Turn the tap lever to the highest temperature.

» Fully open the tap.

» Increase the outlet temperature by closing the tap

slowly.

» Reduce the outlet temperature by adding cold water

or opening the tap further, if possible.





-







» -



» 





» 

AEG DDLT PinControl 24 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info