17
Adjusting the level of conductivity
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and mineral salts of
which quantities vary according to geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conductivity of the water compared to
those prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of the drying sensor based on
conductivity values of the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the appliance. In selec-
tion mode, press simultaneously the buttons 1 and 3. Press the but-
tons down until the pilot lights above each ones begin to flash and
one of the pilot lights indicating the drying phase lights , cooling , or
end cycle remains lit.
Adjusting the level of conductivity:
Press the START/PAUZE button sequentially: the level of conductivity is indica-
ted by the phase pilot lights, which light in various combinations as follows:
Normally, the appliance is factory-set to the highest level; howe-
ver, certain models may be configured differently.
Memorizing the new setting:
Simultaneously press down the buttons 1 and 3 until the previous
drying cycle time appears again on the display and the buzzer sounds.
Lights
Conductivity degree
Approximative value
µS/cm (25°C)
EEnnddee
Low < 300
AAffkkooeelleenn
Medium 300 - 600
ddrrooggeenn
High > 600
