Bedienungsanleitung AEG EWA1110 (Seite 9 von 68) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

563642

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

0 Fill with at least sufficient water to

make it visible on the water level indi-

cator (G), but not higher than the Max.

mark.

0 Close the lid (D) until it engages. The

automatic switch off can only function

reliably if this is done.

0 Place the kettle onto the base (J) in any

position you wish.

0 Press the ON/OFF switch (H) down, the

pilot lights lights up and the kettle

starts to heat up.

The ON/OFF switch (H) only catches

when the kettle is on the base unit (J).

Do not use the water from the first

boiling cycle to prepare food.

The automatic switch off

The kettle will switch off automatically

and the pilot light will go out when the

water has boiled or the kettle is remo-

ved from the base.

If you want to stop the heating process

before the kettle automatically

switches off, simply press the ON/OFF

switch (H) up or lift up the jug from

the base. If you want to reheat water

which has already been heated, press

the ON/OFF switch (H) down again.

When the water has boiled the kettle

will switch off automatically. If the

kettle is only filled with a little water, it

takes longer to switch off.

Safety system

This appliance is equipped with a boil-

dry safety cut-out. This feature pro-

tects the appliance from overheating

when started without water or from

boiling until it is empty if used with

the lid open. If the appliance is acci-

dently switched on without water, it is

automatically protected against over-

heating. The heating process is auto-

matically interrupted. Before using the

kettle again let it cool down for 5-

10 minutes.

Cleaning and care

Always disconnect the kettle from the

mains supply before cleaning.

Never clean the kettle and base unit

under running water or immerse it in

washing-up water.

0 Occasionally rinse out the kettle with

clean water.

0 Clean the outside of the appliance only

using a damp cloth. Do not use any

caustic or abrasive cleansing agents.

0 Hold strainer insert (B) at grip (1) and

lift insert out for cleaning.

0 The heating base is made of stainless

steel. If, however, spots of rust appear,

these are only deposits adhering to the

surface. They can be removed with a

stainless steel cleaning agent.

Descaling

Lime scale deposits on the bottom of

the kettle result in loss of energy and

can affect the service life of the appli-

ance. The appliance switches off before

boiling if the layer of scale is too thick.

It is then very difficult to remove.

The appliance should be descaled regu-

larly depending on the level of the

water hardness. Use a standard des-

caler following the directions; prefera-

bly choose an environmentally friendly,

descaling agent suitable for stainless

steel according to the instructions

from the manufacturer.

0 First fill in water, then a standard des-

caling preparation which is not too

strong.

Do not boil the solution as it could

foam over.

0 After descaling, rinse the kettle out

thoroughly with clean water. Never

pour descaling agents into an enamel

sink and do not reuse them.

822_949_341 EWA1100.book Seite 9 Mittwoch, 12. Dezember 2007 11:54 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG EWA1110 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info