Bedienungsanleitung AEG HSM R 5607 (Seite 27 von 42) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

547293

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Charging the Unit

Turn the unit off.

Connect the power adaptor connector with one

of the following jacks.

The socket directly at the bottom end of the

unit.

Alternatively place the unit in the charging

station. The socket is at the rear.

Plug the power adaptor into a 230V/50Hz wall

outlet.

The charge indicator turns on during charging.

Note:

The charge indicator does not indicate the

state of charge of the rechargeable battery.

Charge the unit before rst use for 10 hours.

Later charges take 10 hours as well.

Note:

The unit cannot be operated with mains power.

Caution:

After 10 hours always disconnect from mains

power supply.

Note Lifetime Rechargeable Battery

You can extent the lifetime of the rechargeable

battery by following these steps:

Only charge after the battery is nearly

exhausted.

Do not charge for more than 10 hours.

Charge the unit at temperatures between

0° and + 40°C.

Clip and Cut Beard

Select the cutting length with the attachment

comb. Press and slide the button (3).

Slide the switch (4) towards the clipper head:

Start with the longest cutting stage and clip

goatee, sideburns or full beard step by step to

the desired length.

Clip Hair

Select the cutting length with the attachment

comb. Press and slide the button (3).

Slide the switch (4) towards the clipper head:

Start with the longest cutting stage and clip

your hair step by step to the desired length.

Outlining and Shaving the Neck

Remove the attachment comb (1) and slide the

switch (4) towards the clipper head.

•

▪

•

►

•

The clipper head allows precise outlining the

shape of the beard, even in difcult to reach

places as well as a clean shaving of the hair-

line at the neck.

Finish Operation

Slide the switch (4) down.

Cleaning and Maintenance

Regular cleaning and maintenance ensures

optimum results and long lifetime.

Turn the unit off and disconnect from mains

power supply, if necessary.

Warning:

Do not submerge the unit in water.

Caution:

Do not use a wire brush or other abrasives.

Do not use sharp or abrasive cleaning

agents.

Use the cleaning brush to remove remaining

hair after use.

Remove the attachment comb (1).

Press the two buttons (2) at the rear of the unit

to fold out the clipper head.

Regularly apply 1 - 2 drops acid-free oil to the

clipper head.

Fold the clipper head back after cleaning until

it locks in place.

Clean the casing with a slightly damp cloth, if

necessary.

Replace the attachment comb.

Noise emission

The workplace-related emission value is less

than 70 dB(A).

Technical Specications

Model: .............................................HSM/R 5607

Power supply adaptor: ...............230V, 50Hz, 3 W

Output power adaptor: ...............DC 4.5V, 150mA

Protection class power adaptor: ........................ ΙI

Rechargeable battery: ...................1.2V, 800mAh

Run time: ...................................max. 35 minutes

Charging time battery: ........................... 10 hours

Net weight: .............................................0.140 kg

Subject to change without prior notice!

•

►

•

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG HSM R 5607 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info