775168
28
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
1. Touch the Start/Pauze - Départ
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ différé
button repeatedly until the display
shows .
3. Touch the Start/Pauze - Départ
Pause button again to start the
programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze - Départ
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ différé
button repeatedly until the display
shows the desired delay time.
3. Touch the Start/Pauze - Départ
Pause button again to start the new
countdown.
12.7 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze - Départ
Pause button, the maximum declared
load indicator goes off, the indicator
flashes, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ Pause
button to start the programme again. The
ProSense phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wol/
Zijde - Laine/Soie,
programmes with short
cycles and without washing
phase.
12.8 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running: .
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
.
During the washing cycle, the appliance
mixes the detergent, the stain removal
www.aeg.com28
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für AEG L8FEC96SV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von AEG L8FEC96SV

AEG L8FEC96SV Bedienungsanleitung - Deutsch - 52 seiten

AEG L8FEC96SV Bedienungsanleitung - Holländisch - 48 seiten

AEG L8FEC96SV Bedienungsanleitung - Französisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info