Bedienungsanleitung AEG NSH 65 (Seite 11 von 22) (Deutsch, Englisch, Holländisch, Französisch)

464380

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

For the Fitter

Ö Screw the hexagonal screws (7) into the drilled holes up to the point at which the natural stone

heating unit with the open slotted holes in its wall mountings (2) can still be hooked on behind

the screw head.

Ö Hang the natural stone heating unit (do not allow to topple or tilt – danger of breakage) and

tighten up the hexagonal screws. In this process, take care to ensure that any stresses which

occur are compensated for by slightly loosening the securing screws (6) in the natural stone

slab.

These should subsequently be retightened up to the stop point (overtightening can cause

dowels to become loose).

2.5.2 Electrical connection

Connect the natural stone heating unit only to a 230 V 50 Hz alternating current supply.

If the mains connection lead is shortened, take care to ensure that the natural stone heating unit

can be taken off again, even without disconnecting the connection lead.

2.6 First start-up

When the natural stone heating unit is heated up for the first time, a heating-up time of

20 minutes should not be exceeded. The slab must then cool down for at least 60 minutes.

This measure is to be repeated one further time.

In the first two days, the heating should be built up to the desired room temperature in stages.

This avoids hairline cracks developing. If hairline cracks should nevertheless develop, this is not

dangerous and impairs neither the functioning nor the safety of the natural stone heating unit.

2.7 Handover

Explain the functions of the unit to the user. Draw his or her attention to the safety instructions,

in particular.

Hand the operating and installation instructions to the user.

2.8 Special accessories

Control of the natural stone heating unit is effected using the room thermostat.

RT 500: Room thermostat with thermal feedback, switching capacity 10 A 250 V.

RT 600: Room thermostat with thermal feedback, switching capacity 10 A 250 V.

RT 601 SN: Room thermostat with thermal feedback, with power switch ON/OFF,

switching capacity 10 A 250 V.

RTE 900 SN: Electronic single-circuit controller with power switch ON/OFF,

switching capacity 16 A 250 V.

English

3. Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.

The installation, electrical connection and first operation of this appliance should be carried

out by a qualified installer.

The company does not accept liability for failure of any goods supplied which are not

installed in accordance with the manufacturer's instructions.

3.1 Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the

national regulations for waste processing.

3.1.1 Recycling of obsolete appliances

Appliances with this label must not be disposed off with the general waste. They must be

collected separately and disposed off according to local regulations.

02 Inhalt NSH.p65 19.05.2005, 12:1111

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

AEG NSH 65 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info