473798
30
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
Protect PV.500 Operating Instructions
26 of 70 80000031354 BAL
5 System Function
5.1 Description of Sequence Control
As soon as the equipment's control module is supplied with
voltage, sequence control starts.
Initially, the load interrupter switch Q4 remains open. Once the
initialisation phase is complete and if no deactivating faults are
pending, the load interrupter switch Q4 is closed. During
subsequent operation, the switch is only opened by deactivating
faults (Æ chapter 6).
The inverter output contactor K7 remains open initially. The
contactor is switched by the sequence control.
The figure below provides a graphical illustration of the sequence
control statuses.
OFF
Waiting for feed
conditions
Fault
Operation
Night
Feed-in
conditions met
Operating
conditions
no longer
met
ON command
OFF command OFF command
OFF command
Daytime detection
Night-time detection
Fault
Fault
Fault
acknowledgement
OFF command
Maintenance
Delay
complete
Fault
Figure 6 Sequence control
5.1.1 The "OFF" Status
The equipment has been switched off logically via the DOU or the
master control unit.
The equipment is running without faults, the monitoring systems
are not activated.
In this status, no power is fed into the mains.
Possible change of status:
The status can be switched from "OFF" to "Waiting for feed
conditions" by switching the equipment on via the DOU and the
master control unit.
5.1.2 The "Waiting for Feed Conditions" Status
The values of the DC voltage on the PV cells, the mains voltage
and the mains frequency are observed by the equipment.
The monitoring parameters values are checked regularly.
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für AEG Protect PV 500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von AEG Protect PV 500

AEG Protect PV 500 Bedienungsanleitung - Deutsch - 136 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info